Jump to content
SAU Community

Recommended Posts

All parts are out of a 1993 model R32 Skyline 2 door. Parts include:

Drivers seat $50

Rear Seat $60

Rear centre seat belt $20

Window wiper motor $40

Air con pipe (firewall to compresser) $20

GTST Bonnet (Silver) $100

Drivers door (Black) with glass and power window motor $100

Boot Lid (Black) Slight repairable damage $30

Stock dump pipe (Turbo to cat) $30

Stock Cat $20

LSD Diff centre $180

Manual Tail shaft $100

Brake Booster $40

Rear Brake calipers + discs $60 the pair

® Rear quarter trim (Bottom half) $20

Scuff plates + Clips $30pair

Pioneer detach face stereo 200w $20

Base 10" sub in box 500w $20

Indicater stalk + horn wire (Complete unit) $100

Boss kit $30

Front strut brace $30

Interior light $10

Rear view mirror $10

(L) Electric mirror (Black) $50

Door check straps both $20

All door lock rods + Clips (both doors) $20

Electric sunroof switch + Interior light $50

Centre dash tunnel surround $10

Passenger glove box door $20

Climate Control Unit $100

Nismo gear knob + handbrake lever both new in box (Never used) $50

Drivers side plastic guard liner $20

Space saver spare wheel $40

Timber plate to cover spare wheel $20

Stereo brackets + Compartment $20

Fuel Flap (Black) $40

Fuel Cap (Nissan) $10

Number plate lights + wiring and fuses $20

Lots of RB20det Engine parts: Motor only done 82000km:

Crossover Pipe with BOV mount + gasket $50

Top + Bottom Radiator hoses, near new $30

Clutch Fan $60

Coil packs x6 $80

Coil pack plates + bolts (to hold coil packs in place) $40

Igniter $40

Pulley belts x 2 $20

Throttle body (Complete) $50

Inlet manifold $80

Stock turbo + Wastegate actuator $350

Stock turbo oil + Coolant lines $30

Crank Angle Sensor + Bolts $50

Stock front mount under bonnet piping (all) $60

Alternator (Gen Nissan) $60

Power Steering pump with bracket $100

Power steering reservoir $20

Century Battery, near new $50

Air flow to BOV Steel pipe $20

Engine mounts $50 each

Harmonic Balancer $80

Fly wheel $60

Starter motor $80

RB20det Engine Block and head Complete $500 Good for someone who needs a bare block and head

and can swap all there stuff over onto. E.G: If your RB20 is blown, heres a good motor for you,

just need to swap all your stuff over.

RB20det 5 speed Gearbox (No crunches, or noises) Very clean, smooth and quiet box $500

Im located in Ashfield (Sydney)

Postage can be arranged at buyers expense

PM or contact me on 0415126075

Cheers Sam

Link to comment
https://www.sau.com.au/forums/topic/310465-wrecked-r32-skyline-rb20det-parts/
Share on other sites

Any mint sunroof parts kickin around? I need it all except glass, switch and motor.

Thanks.

Mike.

Hi Mike

Sorry mate all I have for R32 Sunroofs is the switch unit with the interiour light.

Let me know if you want it.

Cheers Sam

have you got the tyre plackard? if so how much

Hi mate

Sorry I don't have the tyre plackard. I think you can get them on ebay bro

Cheers Sam

Hey bud i'm looking to buy ecu + wiring loom, airflow meter and maybe the coil packs and igniter.

How much $$ and will you post to S.A?

Hi mate PM Sent

  • 1 month later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...