Jump to content
SAU Community

Where To Get Childseat Anchors Installed? What Compliancing Workshop?

Rolls

By Rolls,
in South Australia

 Share

Recommended Posts

Rolls Grand Master

Rolls

Posted
Posted

I just took my car through regency for an engine swap inspection and VIC -> SA rego transfer and they failed me due to lack of rear eye level brake light and lack of child seat restraint anchors.

Does anyone know where I could get the anchors installed? I imagine most compliancing workshops could do so, who would people recommend that are cheap?

Also the brake light, I assume any light would really work, I can install it myself so I guess I just need to know where to buy one. Is this something sprint auto parts etc would sell? Or should I speak to the compliancing guys?

I would ring around but everywhere is closed atm, looking forward to everyones suggestions.

Thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • hardsteppa
      R-chassis INNER tie rod torque spec?

      By hardsteppa · Posted

      Not sure if you're being serious? I, and all the car people i know, ALWAYS use a torque wrench for wheel nuts. I assumed any car person, apart from tyre centre monkeys with rattle gun in hand, would do it properly.  Anyway, no further reply from me on this unless legit discussion from OP or his query so, over to you, knock yerself out.
    • PranK
      Wheel refurb?

      By PranK · Posted

      I was wondering about this. I'll do some research.
    • Predator1
      Rb26 iron block limit

      By Predator1 · Posted

      Why not? Since mines been built, I've used low boost maybe 5 times.
    • GTSBoy
      gauge needle removal

      By GTSBoy · Posted

      Yeah, so widen your search to any Nissan speedo first, then go wider if needed. I will say though, that there is a better than even chance that what I said first will likely come into play. They quite possibly won't come apart without damage. I tried to disassemble a stepper gauge that I wanted to repair. There was no way that needle was coming off the spindle, and I could not see how the spindle would come out of the mechanism behind. Assembled once, never to be disassembled, was my conclusion. Could be the same on the R34 cluster. Failing that - take the cluster to a workshop that specialises in automotive instrument work. There's usually at least one in every Australian city. They'll either be able to do it for you for small cost, or tell you it can't be done. It might be that "it can't be done" unless you follow some arcane procedure, including trickiness to glue it back together or something, that only experienced techs know.
    • GTSBoy
      R-chassis INNER tie rod torque spec?

      By GTSBoy · Posted

      Well, given that I, an engineer, almost never bring out the torque wrench to tighten up chassis bolts, despite fully knowing the theory, and instead rely on feel, which I happen to know is exactly how the majority of mechanics do things, should tell you the level of actual peril that exists from not achieving exactly 88 Nm of torque. How about if I just say then that 88Nm is at the lower end of the correct wheel nut torque range? Everyone knows how to tighten a wheel nut, right? And almost no-one ever brings out the torque wrench for that task
×
×
  • Create New...