Jump to content
SAU Community

Recommended Posts

My car was imported late 2007, early 2008. Would there be anyway I could find auction details for this car?

It's probably a shot in the dark, but I thought I would ask, as I was curious what grade / km the car came in with etc.

Is there any hope?

Chances are pretty much zero. Check on here to find out who complied your car, then ask the workshop.

http://raws.dotars.gov.au/rawswebpublic/RAWPubVehSearch.asp

agreed, chances zero or so close as to be within rounding error of zero...

1. car may not even have been bought at auction.

2. most likely the buyer looked the car up on-line or at the auction house's terminal and never printed a hard copy of the sheet.

3. if the car was bought at auction a copy of the sheet will be given to the agent/buyer or left in the vehicle, most likely at this point they just chucked it out.

4. remember, the auction report is just a basic spec sheet and inspection guide of the car. it doesn't matter what condition the car was in 3 years ago. it matters what condition it's in now.

5. the sheet wont tell you anything you can't better see with your own eyes. all buyers use the sheet just as a guide to see if a car is worth going to see in the metal or not. after that they base buying decisions on what they can see in the metal.

like chef suggested you could try the compliance workshop but they may never have seen or had the sheet either. also ask the bloke you bought it off. but no official body will have it. and zero chance of trying to get it out of an auction house.

maybe try googling your chassis number and see if anything pops up?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...