Jump to content
SAU Community

Management Issues

Sampo

By Sampo,
in Engines & Forced Induction

 Share

Recommended Posts

Sampo Contributor

Sampo

Posted
Posted

Hello,

Still new to the forums and getting used to the layout but here seems like the best place to post this.

Basicly ive got a RB25/30 in a R33 skyline. We're looking at using a Nistune chip which isnt supported in the R33 ecu but is in the R32 etc.

Will be using a RE4R01a auto gearbox.

Can i use a RB26 ecu with this gearbox? what computers are compatible with the box.

Will the gearbox engauge first without the computer for the auto?

Will a R33 gtr engine loom plug into a R32 rb26 ecu

Thanks in advance, Matt

Link to comment
https://www.sau.com.au/forums/topic/317495-management-issues/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • cosline
      R32 gtr transmission strength, billet plate

      By cosline · Posted

      I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • joshuaho96
      GTX2867R GEN 2 NO OUTPUT FOR BOOST SOLENOID

      By joshuaho96 · Posted

      From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • MBS206
      Nissan Skyline R34(ER34) Front Suspension Noise

      By MBS206 · Posted

      I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      Summernats cruiser?
    • MBS206
      NC MX5

      By MBS206 · Posted

      Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...