Jump to content
SAU Community

Recommended Posts

Afternoon All,

I have these wheels for sale they are Volk GR-Cs an old 3 piece wheel produced by Rays in the early 90s. They are 17 x 8.5, I am unsure of offsets. One wheel has a small bit of gutter rash but other than that they are in good condition for old wheels. I have centre caps for them but they aren't the original Volk centre caps. The falken tyres are fairly worn but the corsas still have plenty of tread.

Pick up only

PICT0010.jpg

PICT0011.jpg

PICT0012.jpg

PICT0013.jpg

PICT0014.jpg

PICT0015.jpg

PICT0016.jpg

PICT0017.jpg

Contact me on 0431 320 689

Price $700

Link to comment
https://www.sau.com.au/forums/topic/319062-volk-gr-c-for-sale/
Share on other sites

do u know if they clear brembos??

Not sure if the will clear Brembos I can try and find out the disc type on the weekend.

is the offset stamped on the inside? I may be interested if its under +35

The stickers that normally have all the offset, width n diameter specs are all in Japanese and don't seem to have any specs on them. I'll have to give one of them a proper clean on the inside and see if there are any specs stamped onto the wheel.

When I get home I'll post up some pics of the wheels on my old 33.

  • 2 weeks later...
  • 2 months later...


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...