Jump to content
SAU Community

Recommended Posts

Hey Guys

There is only one great RB, and here it is! Perfect condition.

33K

N1 block

HKS step 3 2.8L kit (HKS pistons, rods and crank)

HKS 1.6mm drag head gasket

HKS exhaust and intake gaskets

HKS oil pump

HKS cam gears

HKS timing belt

HKS fuel rail

HKS 1000cc injectors

N1 water pump

Trust sump kit

Tomei 280 degree 11.5mm lift drag cam shafts

Tomei drag valve spring kit

Tomei titanium retainers

Tomei valve lifter

Race cut valves

Race valve guides

ARP head stud kit

ARP main stud kit

Race main bearing kit

Race crank bearing kit

ATI/Ross pulley kit

Race head port intake and exhaust

PM me.

Edited by rb31
Link to comment
https://www.sau.com.au/forums/topic/319827-dream-engine-28l-hks-step-3/
Share on other sites

Has it done any Km's? If so how many?

The engine has done around 9K kms. Mainly tuning and weekend driving kms. Has been to the track 3 times so hasn't really been pushed.

The torque increase using the step 3 2.8L is extremely significant. I run a T04Z and come hard on boost around 4000 rpm.

Very torquey indeed.

Cheaper to buy one good engine as opposed to blowing 3 dodgy engines!!!

Spend the savings on some brakes!

Cheers

Edited by rb31
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
    • You won't need to do that if your happy to learn to tune it yourself. You 100% do not need to do that. It is not part of the learning process. It's not like driving on track and 'finding the limit by stepping over the limit'. You should not ever accidently blow up an engine and you should have setup the ECU's engine protection to save you from yourself while you are learning anyway. Plenty of us have tuned their own cars, myself included. We still come here for advice/guidance/new ideas etc.  What have you been doing so far to learn how to tune?
    • Put the ECU's MAP line in your mouth. Blow as hard as you can. You should be able to see about 10 kPa, maybe 15 kPa positive pressure. Suck on it. You should be able to generate a decent vacuum to about the same level also. Note that this is only ~2 psi either way. If the MAP is reading -5 psi all the time, ignition on, engine running or not, driving around or not, then it is severely f**ked. Also, you SHOULD NOT BE DRIVING IT WITHOUT A LOAD REFERENCE. You will break the engine. Badly.
×
×
  • Create New...