Jump to content
SAU Community

Clifford Avantguard 4 And Aust Stds

wazza_34

By wazza_34,
in Car Audio & Electrical

 Share

Recommended Posts

wazza_34 Rookie

wazza_34

Posted
Posted

Hi everyone,

Does anyone know whether the Clifford Avantguard 4 alarm/immobiliser complies to australian standards. I ask this because i imported the car with it already installed and wanted to know if it is ok for Justcars.

Also, has anyone had experience with this alarm? is it any good?

Thanks in advance.

Link to comment
https://www.sau.com.au/forums/topic/320269-clifford-avantguard-4-and-aust-stds/
Share on other sites
danielr34 Collaborator

danielr34

Posted
Posted

Clifford make reasonable security systems and usually comply to UK standards or Thatcham Approved, I am not too sure if they have been put through the Australian Standards Testing procedure however, even if they have all the features of an Australian Standards alarm system ie black wiring, 3 point immobiliser etc does not mean they would be covered by insurance. Being that they are not sold here in Australia (that I know of) I would say they have not been tested for AU Standards. In the past I have had to remove a few Clifford alarms from imports in order to fit an AU Spec immobiliser.

Sorry can't give you a definate answer, only what I have seen in my experience.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Chris' Toyota Mark ii JZX110

      By GTSBoy · Posted

      I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • MBS206
      R32 update from 1990's spec.

      By MBS206 · Posted

      With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • joshuaho96
      RB26DETT Sketchy boost mod?

      By joshuaho96 · Posted

      This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...