Jump to content
SAU Community

Recommended Posts

Hey ppls.

Well, I used to be a religious Hard Kandy goer, every second Friday night, from 12 till 10am.

I used to be that guy up on the stage (when they still had the stage) all night going nuts, and the last one on the floor at 10am at close!!

I went between 2 and 4 years ago, and so did all my friends.

But now I'm old and fat(ish) and can't keep up with the yound kiddies like I used to.

Besides, last time I went, a few months ago for their 4th birthday I was dissappointed by the clientel, too many people on the stairs and nobody as friendly as I remember it.

anyway, I used to go.

BASS OUT

Link to comment
https://www.sau.com.au/forums/topic/32563-hard-kandy/page/4/#findComment-660619
Share on other sites

  • Replies 65
  • Created
  • Last Reply

Top Posters In This Topic

Avmin Van burren is playing a 6 hour set @ QBH pitty its at qbh but should be good

Inark SAY NO TO PLUR  **** plur :)

 

Sorry but the only people you will make trouble with is the bouncers if you and nathan  :)   :inlove:  bj.gif

LMAO

Link to comment
https://www.sau.com.au/forums/topic/32563-hard-kandy/page/4/#findComment-660796
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...