Jump to content
SAU Community

Recommended Posts

Hi Guys

I have following items for sale, located in Chatswood, PM me if you're interested

R33 series 2 GTST rear seat in good condition- $50

pickup only

Kakimoto Fullmega N1 + REV 3.5 inch, full stainless catback exhaust for R33 GTSt and GTR- $550

Rare exhaust, 3.5 inch full stainess steel, In good condition overall, only used for 10,000km with slight scratches at the bottom, otherwise its fine.

This is the latest Kakimoto N1, no drone from within car, very nice and quiet and produces a nice note on acceleration, while not being overly loud. Sounds very crisp on higher rpm.

Will take it off car within a weeks time or when there's a buyer, whichever comes first.

http://www.kakimotoracing.co.jp/image_N31307.html

Edited by chiksluvit

its ok, not overly low, the lowest point actually sits slightly higher than HKS silent hi power, and the lowest point is actually the big resonator which is what keeps it quiet..

My car had the sydneykid suspension, so its lowered and the lowest point where the exhaust is, is still more than 100mm, since it cleared police check

Kaki exhaust $450 or near offer

Also have a brand new water pump still in box for sale with gasket, for RB20 and RB30, never used, selling for cheap as i bought the wrong pump. - $45

Edited by chiksluvit

heres a video of how it sounds

it sounds louder than normal since it was taken in a car park, but gives you a pretty good idea of its sound quality

click on picture to see the video

th_IMG_0233.jpg

Edited by chiksluvit
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...