Jump to content
SAU Community

R33 Indicator Problem

TRUSTME

By TRUSTME,
in General Maintenance

 Share

Recommended Posts

TRUSTME Explorer

TRUSTME

Posted
Posted

Hi Guys

All my drivers side indicators are flicking rapidly like when you have a bulb out but all of them are working?

The passenger side are working fine just the problem with all the drivers side.

Could it be the relay? I took the relay out that makes the indicator ticking sound and gave it a bit of a tap but it didn't fix it..

Any ideas?

Thanks

Link to comment
https://www.sau.com.au/forums/topic/330348-r33-indicator-problem/
Share on other sites
t_revz Grand Master

t_revz

Posted
Posted

lower wattage globs or LED`s can cause this. should be 18w or 21w usually. you can change the flasher unit to an electronic one that runs at the same speed all the time no matter the wattage. which is good except you dont know when a globe is out.

TRUSTME Explorer

TRUSTME

Posted
  • Author
Posted

I just recently changed the side indicators to clear ones thus changing the small side bulbs to the orange one's but i changed both at the same time and the passenger side is ok? I'll replace back to standard bulbs again tonight to see if it fixes the problem. Is it possible that the bulbs are faulty? but still work??

Havent touched the front or back.

Cheers

TRUSTME Explorer

TRUSTME

Posted
  • Author
Posted
I just recently changed the side indicators to clear ones thus changing the small side bulbs to the orange one's but i changed both at the same time and the passenger side is ok? I'll replace back to standard bulbs again tonight to see if it fixes the problem. Is it possible that the bulbs are faulty? but still work??

Havent touched the front or back.

Cheers

Thanks guys.. Have pulled all bulbs out looks like the rear indicator buld was the culprit. Poor connection cleaned up the connection and works fine.

Cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      R33 GTST Axles

      By GTSBoy · Posted

      There are several aftermarket options available, from not-too-painful moneyhttps://justjap.com/collections/driveshafts-bearings/products/d-max-reinforced-replacement-rear-driveshaft-set-fits-nissan-s13-s14-s15-r32-r33-r34-c35 and  https://justjap.com/products/crank-motorsport-billet-rear-axles-fits-nissan-skyline-r33-gts-t-r34-gt-t?srsltid=AfmBOorQk4xkGUa98kO7v2ePLUiNt-HRrM2AwWNw9mbSIVE1ujBVwY__, all the way up to The Driveshaft Shop https://driveshaftshop.com/skyline-cv-axles/
    • jdniss
      Forced Performance Hta Turbos

      By jdniss · Posted

      Yeah based on old XRC5964S specs, it looks to be roughly GTX3576R sized? But this 5964S compressor will flow 90lb airflow somewhat similar to the compressors in both the GTX3584RS or G35-1050.. I fully expected the 0.64 rear A/R to choke up top - seems way too small from typical convention - but these are seemingly beneficial over the prior 0.82 results.. Be interesting to see if he comments on the EFR question in that thread - he mentioned in a prior video that BW EFR's were the "cats pajamas 10 years ago", but by the sounds of things all his kits have been using Xona for quite a while now.
    • thozza
      Intro/R33 owner

      By thozza · Posted

      Yeah it’s still got the oem manual gearbox and clutch, only kinda mods are a blow off valve, coil overs, and a aftermarket intercooler. Also had it for about 2 months now with a lovely midnight purple paint on it.
    • Lithium
      Forced Performance Hta Turbos

      By Lithium · Posted

      Yeeeppp, been following a lot of the testing on the latest Xona stuff and there are some mental results.  He also went over 1000hp @ 4 hubs on his Mainline with a XRE6364S (63mm) which was also well into the 20psi range before 4000rpm on a 2.5. Crazy stuff. Fwiw the XRE5964S is basically the modern equivalent of their old HTA3582 - would drive nicely enough on an RB25 or 26, but proven capable of a huge amount of power if you want to spicy with rpm tho even at sane boost levels will make stout numbers 
    • tidi0x
      R33 GTST Axles

      By tidi0x · Posted

      The axels in my R33 seem tired, and have a bit of play in them. I cannot find any new of course, not interested in buying used, but I am looking to see if anyone can identify some cross compatible axles. In the states I have seen suggested for S chassis the J30 axles, however for the skyline (as best I can tell) the lengths are about an inch off (2.5cm) on both sides. R33 my measure L 22" R 24.5" GPT L 22.5" 24.25" J30 L 23.5" 25.5"  so shaft length is probably an inch wider. Not sure if someone has another still remanufactured option besides the J30. I figured worst case I can buy a pair tear them down and swap the center shaft. My other option was reaching out to GSP to see if they cannot piece together a set, since the axle stubs are still manufactured, I wouldn't think it be that hard to find a shaft or make a shaft work. 
×
×
  • Create New...