Jump to content
SAU Community

Recommended Posts

Hey guys im new to skylines australia and I know this topic has been touched many times however I havent been able to solve my problem so any advise would be much appretiated.

I have a r33 which has a ecu modifyed by sam at dr drift so the afm is located between the intercooler and the inlet plenum anyhow I have had a lot of problems with the intercooler pipe blowing off at the afm (which I think is where my problem first started) so I welded a couple of tabs on each pipe and ran a bolt on bar beside the afm to stop it from seperating, once all that was done the car now seems to have a misfire mabe? it runs a little rougher than normal at idle but seems fine to drive untill you hit boost where it coughs an splutters etc on occiasion it will boost in second gear but it over boosts.

I think the fuel pump is fine as its new and it pumps a bit of black smoke out the back while its playing up and also I have tryed a bunch of things to rectify the problem which includes- cleaning fuel filter etc, carn't find any vacume leaks, new spark plugs, pulled the coil packs off my rb26 and tryed them ( splitfires where on the car), inspected the coil harness and added an extra earth, cleaned earth's on motor, tryed a second ignitor,afm & tps, the wastegate was sticking a bit also but have since cleaned around the valve and flange so it now moves freely, I also hooked it up to the consult cable and it shows no erra's though the tps ( first one) was running at .80 volts so adjusted that to 0.45 v.

So as you can see ive had enough of this f**in pice of sh**t so if anyone can help me out here it would make my day.

Link to comment
https://www.sau.com.au/forums/topic/330936-rb25det-misfire/
Share on other sites

check the AFM value during driving on consult

because its been blowing the pipe off you may have physicall damaged the hotwire, its a simple wire after all

Will do mate, when I take a look at the car next its on its second afm though which im pretty confident is in good working order, its gota be somthing like that ive over looked.

Link to comment
https://www.sau.com.au/forums/topic/330936-rb25det-misfire/#findComment-5376204
Share on other sites

Hey guys just thought id run some thoughts past ya,

When the car does boost I carn't hear the wastegate so much yet the boost guage say's the inlet manifold is seeing 22psi which it should be 18psi the wastegate has a 15psi spring in it which leads me to beleve this could a plenum leak, I had allready checked for this but only visualy inspected pipes/hoses etc so are there any suggestions for like a leak down test or something effective without striping everything down?

Cheers

Link to comment
https://www.sau.com.au/forums/topic/330936-rb25det-misfire/#findComment-5378122
Share on other sites

Might have a look at the car this weekend I also noticed it has a slight manifold leak though I wouldn't think it could cause the car to play up this much could it? the engine also seems to be going through huge amounts of fuel is well so im still a bit confused as to what the problem might be?

so come on fella's the more infomation I can get the better im sure some one has had similar symptons any input is always appretiated cheers.

Link to comment
https://www.sau.com.au/forums/topic/330936-rb25det-misfire/#findComment-5382979
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
×
×
  • Create New...