Jump to content
SAU Community

Recommended Posts

Nissan Consult Diagnostic interface

It works on all Nissan cars that have the grey 14pin Consult connector

(you'll usually find it near the fusebox) (This cars are usually build from year 1989 to 2000)

post-61447-1280998733_thumb.jpg

These are some of the screenshots you get on your laptop

post-61447-1280998824_thumb.jpg

Features :

- Interface fitting for 14pin Consult Port of Nissan vehicles.

- Heavy & robust casing for rough service use

- Connects to PC via RS232 or USB

- Powered from car battery over 14pin Consult Port of Nissan vehicles.

- LED to control power and clock function

What can you do with this interface?

- Monitor and Log dozens of realtime parameters

- Check and clear engine fault codes before going to an expensive auto shop

- Adjust the timing and idle

- Power balance testing

- Reset the self-learn codes

- Control idle air valves, relays (AC, fans, etc), timing

- Diagnose customer vehicles on-site

- Speed up troubleshooting of electronically monitored components

- No software is supplied with this device

Available software working with this Interface:

(Note that some of it is not free and need to be purchased)

DDLreader: DDLreader v.15c / DDLreader v.16c

ConZult

ScanTechNissan

Z-Control

SRTalk v.1.0

ZCSetup v.2.0

ZTalk v.1.1

Nissan Data Scan v.1.4

Nissan Data Scan v.1.51

Package including:

- Nissan Consult Interface

- RS232 extension cable

- Usb connection cable not in picture

- I have lost CD with Nissan Conzult shareware software but you can download it of the net

$90

PM ME

  • 2 weeks later...
  • 3 months later...

its RS232, like all the chinese ones. e.g. this. no usb. if like most laptops you dont have rs232, and insist on going for one of these ones, make sure you get a FTDI chipped usb/serial converter (these are the chips used in the proper USB ecutalk/blazt/plms consult cables), which wont be cheap, but will save the bluescreens.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just trying to get my head around this. At 5psi of boost, you turn on your wmi pump, and then you're using a 3000cc injector, to allow flow upto the actual engine, where you have your 6x200cc injectors and a 500cc injector. If the above is correct, what advantage are you obtaining by having the 3000cc injector blocking flow, is this just incase a line breaks between that injector and the motor you can stop flow immediately? Or are the 6x200cc and 500cc less injectors and just spray nozzle?
    • Welcome! New member myself, but I had an R33 back in 2002. Best advice I could give, based on my experience: if you're running the factory turbo, be very conservative with boost. I made the mistake of just fiddling around with the boost controller and cranking the boost for fun, and the end result was my intake pipes popping off frequently from the constant deluge of oil that was being blown into the recirc by the stressed-out turbo, which itself was siphoning oil from the engine and farting it out both sides of its centre bearing (or something to that effect). If I could do it all again, I would have gotten a new turbo and had a tune dialled in professionally and then just left it alone! Funny you mention the metal shavings in the gearbox, as I had the same thing - the probe plug (magnetic drain plug, essentially) would come out caked with shavings. At least it was doing its job. Not sure if that's just sacrificial wear and part of the deal, or if my gearbox was shagged, but I wasn't abusing it. Enjoy the R33 - they're a dying breed, and if they weren't $35k+ on CarSales in Queensland, I might have picked up one of those again, instead of the 370GT I own now (though I'm loving the 370GT, that big 3.7L V6 just hits different).
    • Howdy folks. I owned an R33 back in 2002, which was thoroughly beyond my capacity (financially speaking) to maintain/insure, so we parted ways in 2004. Fast forward 21 years (to literally yesterday, in fact) and I'm now the proud owner of a 2007 V36 370GT. I'm happily surprised by how much power the VQ37VHR makes, compared to the RB25DET, considering the latter is turbocharged. I had planned to add a turbo at some point but I'm on the fence about whether I'll even need it (though I do love the sudden onset of extra torque). Any other 370GT owners around the traps, I'd love to hear about your experiences with this car (good and bad).
    • Perhaps the answer is... more jacks!* *proper jacks must be used.  
    • I NEVER think about using a scissor jack unless there is absolutely no other alternative. f**king things are dangerous, annoying and stupid.
×
×
  • Create New...