Jump to content
SAU Community

Recommended Posts

hey all, i bought this setup not long ago to put in my 180 but unfortunatly things have changed for me and if i can make most of what it cost me back ill be selling it up.

basic rundown.

RB26DET

sard 600cc injectors

tomei poncams

modded sump for rwd

unknown bottom end. can only be presumed standard.

Heavy duty clutch

loom etc.

$3800

T78 33d kit.

trust mani

hks 50mm gate

dump pipe

turbo looks to be in really good condition other than some slight marks on the comp wheel (run with no filter)

$2900

Power fc

Greddy twin intake

Z32 AFMs

fc commander

$1400

trust oil cooler kit.

sandwich plate etc all lines included with earls fittings

$800

i have other little things like stock ecu, a/c compressor etc.

nothing will be seperated until ive sold the motor/turbo kit.

cost for all of the above complete is $7600 firm.

post-29077-1284532170_thumb.jpg

Edited by boostd gem

interested in the turbo kit.

what power did u make with this setup at what rpm. do u have a dyno graph?

what is a t78 rated at horsepower wise?

thanks

julz

for anyone interested, this wasnt run without a air filter, so no worries there, it's just one of the air filter's was damaged so i didnt worry giving it to him. they were run with blitz twin pods so there is no issue there. I'm also pretty sure this engine runs oil restricters due to the oil pressure readings it was getting (always really good).

this engine is built for huge power, if that's what u want, then u cant go past this package.

Is this your old engine nisskid?

yeh mate, really strong engine, and the T78 was amazing, i didnt wanna get rid of it, but had to let it go as i was in too much debt because of it haha

i just wanna see someone get this and give it a proper tune, see what it can do, i lost the tune not long after i bought the car and was too retarded to work the boost controller, so it ran on a base map and 12psi for most of the time i had it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • In Vic it would be a defect regardless of whether or not you cut a hole in the sheetmetal for the return pipe. The rules in Vic are shitful, and are generally interpreted as you can "make 2 mods to the intake system". Putting an FFP and an FMI onto it will almost certainly be seen as some huge number of intake mods. You really need to speak to an engineer before doing this stuff in VIC.
    • planning a r34 rb25 de+t with some other work, rather just have it done in a shop due to space limitations any recommendations? I have most the parts already I seen online Moore Performance and DR Drift any advice appreciated thanks 
    • I’ve read the previous posts so just looking for latest information on how people have dealt with front facing plenum is it a defect etc or didn’t pass roadworthy or was it not noticed? Have a r34 and deciding if I should make a hole on the driver side or not.  I know some people have said blitz return flow but I might get rid of the stock intake down the line for a plenum so I rather set up for that now plus I already have a standard Intercooler. Car is mainly stock  Thanks. 
    • Actually, if having and keeping the stock ECU is the plan, the correct answer is to put Nistune into the ECU and improve the situation, not just look at it.
    • Wrong side of sydney for me coming from Goulburn, but you should head along, all ages of Skylines will be very welcome
×
×
  • Create New...