Jump to content
SAU Community

Recommended Posts

  • Replies 172
  • Created
  • Last Reply

Top Posters In This Topic

most half cuts go for 2500 ( r33 ) but not stagea half cuts.

u say 1500 but thats for a r33 motor, box ect not a s2 awd stagea that has a r34gtt rb25.

price is good i think

Edited by whitenight27

haha true true too much boost.

i shore goodo thinks its worth what his asking for.

the extra 1000 is because its a r34gtt and not a older r33 motor.

for 1 the turbo is a lot better than the 33.

the 34 turbo can run little more boost and has a bigger rear housing but still responsive

33 turbo has a ceramic compressor wheel while the 34 turbo has nylon compressor wheel and better for hi-flowing

i will just say don't think u will ever get a 34gtt motor ecu and piping for 1500. r33gtt yer no probs

34 will have low ks and a lot newer motor than a 33 rb25

Edited by whitenight27

whiteknight27you will have to be a little more clear when you say what is left. I prob dont have much that you need but if you ask for what you actually need i will be able to answer yes or no . As for the 34 front it went on to my new one

menthol369 sorry but the motor is gone got $2300 motor loom and ecu

thort u would get around 2k for it lol.

any how need things like

peddle box

console

hand brake and cable

any thing i would need to change my auto 2 man

I belive i do have the peddle box and clutch master cylinder but i think thats about it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...