Jump to content
SAU Community

Recommended Posts

Guys how renowned are the rb25det from getting oil leaks?

I appear to be leaking a few drops every time i pull up after driving for a while and appears to be from the rear seal..

Any ideas what cost would be involved in getting this fixed. I just havnt the skill/muscle to drop the box and do it myself.

regards,

Darren

Ps: the motor was only rebuilt (stock) about 2000 kms ago, would a warranty cover this?

Link to comment
https://www.sau.com.au/forums/topic/342316-oil-leak-question/
Share on other sites

Obviously it depends on what the warranty covers... but I'd say it should be, unless you're over the kms or time.

Rear main seal could be around $500ish I had in my head... Mine's been dropping a little oil too so I'm trying to plan to have it changed in the next month or so.

man,

For about $8 bucks I should give this a go. Gotta get a hoist and a couple of stongs mates over...

Ps: I have have sent sms to the guy who repaired my motor to see if covered by waranty and he said to bring it pass and he will consider/check depending on mods done since. (only coils) so maybe i will be in luck....?

Edited by itshimdazza

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...