Jump to content
SAU Community

Recommended Posts

I bought some ramps yesterday to do my gearbox oil, then discovered I couldn't drive up them with my front bar, so had to do some dodgy manouvering so that they were on a downslope before I could drive up them....when the car was up on the ramps, the base of one ramp was like only half on the ground due to the dodgy incline......safety first:rofl:

* extremely slow clap*

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

james.. ya noe you will be the first one i called if we are going down....  

but yeah... who you going with, Warwick?

thought I might go there with the missus on the way back from the airport....you wanna come?...prolly around the 8.30 mark

*remembers Glenn eats at midnight*

thought I might go there with the missus on the way back from the airport....you wanna come?...prolly around the 8.30 mark

*remembers Glenn eats at midnight*

ok.... if you go @ 8.30. There's gonna be plenty of cars and ppl cos its friday nite. I reckon its best you parked @ the multistorey carpark.

you still got the address of the place? i will give you a call if i can make it down.

you sure its your wife and not some hot 18yr chick? :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
×
×
  • Create New...