Jump to content
SAU Community

Recommended Posts

Had this for sale for awhile need it gone. Only contact me if you have cash ready no swaps.

Imported myself almost 2 years ago.

97 JZX100

145ks

Auto

sunroof

Mods: CST coilovers

Exhaust

Rear 34 GTR rims Front Work CR KAI 18x9.5+12

bleed valve

sony deck with USB port

front and read camber arms (various)

selling as its been my second car for about two years, gets driven once a week no more need for it. never missed a beat all electrics work engine is healthy and running fine. happy for you to organise mech inspections. Car has been defected for almost a year now, just sits in a garage and driven around the block.

$10,000 as is (defected for ride height and wheels to big) standard rims will be included.

$12,500 with defect cleared and rego (I dont have time to organise this hence the cheap price above)

contact me on 0423 759 200 or [email protected]

chaser.jpg

chaser2.jpg

Link to comment
https://www.sau.com.au/forums/topic/355379-jzx100-chaser/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...