Jump to content
SAU Community

Recommended Posts

This Group buy is for SA only.

i am getting some stuff from OS, so i have this group buy which can share a bit of postage for me and SA people can get cheaper stuff. :(

Rear cradle spacer for R32, 33, 34 both GTS & GTR, S13, S14, S15, A31

nomal price: $170

now: $150

cai box for R33, 34 gts & Gts-t only

Nomal price: $190

now: $170

condition : pick up from my place! (5 mins from Marion shopping centre)

end of this GB - 28 March

interest buyer can reply this thread or PM me :wavey:

Very interested, but i have fmic that runs pipe from drivers side into engine bay over fan and connects with original alloy elbow off throttle body. I dont have the original cold air feed because the intercooler pipe passes through its original position. Is it possible that the cold air box could be modified to pick up air from the now empty hole where the factory intercooler pipe once ran? Could this be done for me even if slightly dearer than the buy price.

Do u have an example of the cai box in a car here??

Very interested but i dont have the original cold air feed and also the intercooler pipe goes rite next to the air pod.

So it would be good to see an example first.

Also interested in the rear cradle spacers.

i haven't got it in my car YET (getting mine's though this GB :( ), have seen the real thing, it should be big enough to fit most air filter, at least my HKS and the apexi one in the pic.

car with FMIC should not be any problem as the car in pic also got a fmic.

will confirm about cold air feed.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...