Jump to content
SAU Community

Recommended Posts

Injectors

550cc Top feed

denzo injecotrs i had them cleaned ( cost me 125 )

had new orings put on aswell

will fit 11mm and 14mm ( plugs included )

330 Firm

Avo Intercooler ( good quality )

Bloack in color Return style.

couple of bent fins but not twisted or anything

i bought for 830 and made 306 rwkw with it

Comes with all piping needed

looking for 250 FIRM

SPACERS...........

4x114.3

20mm $80

30mm $75 does not come with nuts ( but i know where to get them )

5x114.3

25mm $75 does not come with nuts ( but i know where to get them )

im tracking down nuts for them now

Wrecking R33 Skyline PARTs

Rear Calipers $80 Firm

Steering Rack $40

Stock Turbo

minimal shaft play

no actuator $250 Firm

Rb25det done 120xxx

And has had

NO modifications

( not even pod filter ) $1680

Rb25det Auto gearbox

Drove fine $250

R33 Tail lights

(tiny chip where indicator is) $70 PAIR comes with center garish

White Rear bar ( STD )

ill throw reo bar in $70

R33 white s2 Wing+boot $50 FOR BOTH!!

R33 Front Fenders $65 for left

Left one has a small paint $75 for right

chip where headlight is $120 for both

drivers side door skine

( GOOD NICK s2) $40

boot carpet $20

Rear seats $50

Oem Clutch ( looks like there

is alot left ) $80

Turbo Smart Bov Adapter (alloy) $18

s1 Centre Grill $18

S14 S2 PARTS

Hand Brake Set up

Lever plus cables $90

Brake booster and master

cylinder $90

Right hand door excluding

switch has some paint fade $90

Drivers door switch $35

Sunroof i have

comes with

glass + motor + lineing

$40 Stupid low just want it gone

S2 boot + wing

paint has faded $45

Stock bov and pipe that

runs over engine $50

Auto Diff ( will fit man )

only done 130xxx minimel play $110

glove box ( good nick ) $30

Good nick Stock AFM $50

Ignition pack $40

Washer bottle ( no cracks ) $30

Mirrors Left And Right

tiny bit of paint fade

Black base red mirror $45 per side

S14 FULL rad support $60 CHEAP!!!!!!!

s13/180sx

Drivers Seat in ok condition(sr)$25

Stock Rear bar (black) $25

Stock ca front bar( Grey ) $25

Thats all i can think of right now

i have alot of photos so if you want to ask any questions or see anything just ask

[email protected]

0430106414

located in s.e suburbs Melb

willing to do swaps for r32 Gtr passenger / rear seats

Link to comment
https://www.sau.com.au/forums/topic/366325-after-market-stock-heaps-here/
Share on other sites

20mm 4 stud are gone but if your are talking about the 5 stud. the studs on your car wil poke a tiny bit

and yes i will courier if you organise it :)

if you still want pics throw me a sms

0430106414

can you send me pics of the AVO intercooler ? what was it fitted too ? curious on what brackets you have. either email or sms [email protected] or 0417506282

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...