Jump to content
SAU Community

Recommended Posts

hey there guys. got defected for being to low the other day and need to get a roadworth. before i went to take it in i gave it and the engine bay a wash. i then backed it out of the wash area and into the garage. about 10 minutes later i went to take it for a drive and it had a miss at idle. i went to keep driving it as i was heading to a workshop anyway only to have the car almost die when i went to drive off. and didnt improve at all down my drive. so i took the car back to the house. its a series 1 r33 gts with the only engine mod being a k&n pannel filter. any suggestions on what the problem might be. thanks

Link to comment
https://www.sau.com.au/forums/topic/369131-r33-gts-missfire/
Share on other sites

Depends on what the problem is. If it is a missfire as in the a cylinder is missing a spark and causes the engine to make a noticeable jump then your coilpacks need to be replaced. This is likely as your coilpacks are pretty sensitive (shock, moisture). Also depends what else you got wet and how the engine is behaving so try and give us some more details.

the car runs great first thing when the engine is cold. as it starts to warm up it starts missing at low revs. the hotter the engine get the worse it gets at higher revs. so when it first starts to warm up the car runs well when travelling at 2500 rpm but almost stalls at idle. then when at operating temperature the car misses badly at revs and only slightly at idle. will be checking coils.and plugs this morning

It'll get better over time but it'll wear the f**k out of your engine.

Pull every spark plug out, dry out each plug/where it plugs into.

Make sure none of them are f**ked. You may want to grab a piece of fine-grit sand paper and clean up the sparking parts of the spark plugs.

Then, you need to get in your car, drive down to the local mechanic, tell him what you did and let him fix it.

Running worst when warm reminds me of my coilpack issue... i covered it in silicon however I'd recommend you leave that resort till last. You want to attack the immediate problem as opposed to imminent problems.

But yeah tbh I wouldn't even bother touching the car myself.. your mechanic will have all the replacement parts and knowledge you need to fix this.

Edited by SKITTLES

geez i really cant remember the voltages but if you had a power fc it would tell you automatically. There's a few posts that explain which terminals are which and what the correct volatges are. Not too sure if you should bother with this one, basically the car wont be able to hold idle and will just die if the afm is ruined.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...