Jump to content
SAU Community

Recommended Posts

Make: Nissan

Model: R33 GTS-T

Transmission: Manual

Colour: Black

Location: Adelaide

Currently registered? Yes till 18/8/11

Price: $9,800 (or will swap for a car of lesser value + money my way, or less without wheels)

Contact: 0402 902 759

Comments / Modifications:

Engine fully rebuilt and balanced with CP forged pistons, rings, new bearings, gaskets as well as rebuilt head and comes with all receipts for engine work. Combined with FMIC, Bosch fuel pump, exhaust, Exedy clutch and Apexi coilovers, makes for a good all-round package.Also comes with a VIPER 2 way paging alarm.

Compression tested - Between 179-176psi for all cylinders, an extremely good result.

ENGINE

- Full engine rebuild with CP forged pistons + rings, fully balanced with all new bearings and gaskets.(Comes with $10,000 Worth of receipts for engine + clutch)

- Rebuilt head

- Exedy Super Single Brass button Clutch

- Bosch 040 Fuel Pump

- Turbosmart boost controller

- Front Mount Intercooler

- 3A Racing pod filter

- 3" front and dump into a 3" cat and 3" cat back.

SUSPENSION

- Apexi N1 Coilovers

- Endless hicas lock bar (Engineered with paperwork from Doug Potts & and passed through Regency)

- Replaced Diff with 4.11 Ratio

INTERIOR

- Re-trimmed Leather Steering wheel, Perfect condition

- Silver Dash Surround

EXTERIOR

- S2 rear wing

- Standard S1 M Spec Front Bumper (average condition, Has a crack in the front)

- Jun rear bar ext

- DNA Wheels. 17x9 +30 all round

- GTR type grill

- nismo indicators

Bad Points;

Could do with a polish as its been stored in the shed for 6 months

imgp2209small.jpg

imgp2227small.jpg

imgp2183small.jpg

imgp2244small.jpg

imgp2248small.jpg

Edited by Trackwork
Link to comment
https://www.sau.com.au/forums/topic/371828-r33-forged-rebuilt-motor/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...