Jump to content
SAU Community

Recommended Posts

hey guys, i have a r33 gtst skyline and have just reciently intstalled the apexi PowerFC and hand controller. The rest of the car is pretty stock, except for 3in exaust. The FC is still in its base tune. What i have noticed though is if i give it a bit, it's not too hard to get the FC to flash up 100% duty cycle for the injectors (or close to it).

whats the most logical cause for this, injectors or fuel pump on the way out?

leigh.

Link to comment
https://www.sau.com.au/forums/topic/37231-100-injector-duty/
Share on other sites

Most logical cause is the the base map is set up for greater fuel delivery to take into account more mods than you have (ie is tuned rich).

Get it on a dyno and tune according to the air/fuel ratio. Will probably find that you'll gain power as well as reduce fuel consumption.

Link to comment
https://www.sau.com.au/forums/topic/37231-100-injector-duty/#findComment-745695
Share on other sites

Guest INASNT
just get GT-R injectors ,pump,FMIC,POD and youll fly .. 13 seconds garunteed.

that wouldnt cost you much.. how much boost are you running ? you must be on atleast 11psi to max out the injectors and fpump

bahahaha!!!

U have obiliously have not done any of these in your car have ya?

B33st

If u got stock everything else then ur injectors shouldnt be maxing out.

Get the injectors ultrasonically cleaned and checked coz they must be a blockage somewhere, or your fuel pump is cactus. Also if u continue to drive your engine will be pining up high with the base maps

Link to comment
https://www.sau.com.au/forums/topic/37231-100-injector-duty/#findComment-750702
Share on other sites

I have already purchased new 044 fuel pump, sx reg, surgetank. Also no the way are a Greddy Plenum, Q45 afm + throttle body.

Had just put the FC in and given it a bit or a run to see how it would go. Ran like normal, except for the fact that the hand controler was easy to get to show 100% duty, never showed more than 17 on the knock meter though.

as soon as i get the plenum etc, will installing all the bits and taking it to ARE (QLD) for custom cooler / piping job.

then its time for a tune, and i guess i will find out if new injectors are needed too.

leigh.

Link to comment
https://www.sau.com.au/forums/topic/37231-100-injector-duty/#findComment-751564
Share on other sites

yeah am working towards the turbo...

I wanted to do my build-up in 2 stages.

1. support systems

2. big turbo and big boost.

i pretty much have all the support items now(see last post). so ill get them installed + tuned and it'll then just be a matter of waiting till i have the funds for the turbo.

leigh.

Link to comment
https://www.sau.com.au/forums/topic/37231-100-injector-duty/#findComment-753226
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I drive the Tiguan much harder than the Skyline in all conditions, because it just grips and hooks, unlike the R33 shit box
    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
×
×
  • Create New...