Jump to content
SAU Community

Recommended Posts

Hey,

I have an R32 GTR, recently replaced the battery due to starting problems. This fixed the issue for a while but am having dramas again:

1. I started my car after work to drive home, it started fine but none of the electrics (tail lights, interior lights etc) worked for the entire drive home.

2. A couple of weeks ago i charged the battery and it started fine.

3. This weekend It started with the help of a jump start, however I tried it again today and it started but as soon as the leads were disconnected the car died.

4. I put the battery charger on the battery whilst in the car but it wouldnt charge at all, the light came on to say the charger is on but the charge light wouldn't light up.

5. I put the battery charger on the battery whilst out of the car and the charger said the battery is fully charged.

6. I've checked all the fuses and they are all good.

I'm thinking the alternator is probably stuffed and maybe even the new battery aswell. Any help would be greatly appreciated and if anyone has any auto sparkies they could recommend SOR.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/374717-gtr-wont-start/
Share on other sites

sounds like you have a broken wire on the main harness into the car. or main fuse/fusable link fried.

possible ground issues as well

and a good possibilty of a fried diode pack in the alternator.

get a volt meter,

battery voltage engine off

battery voltage if the engine is running if you can without jumpers on another car/ battery start pack is ok

check the grounds on the frame to battery, and to engine

are the connections tight and clean on the battery.

can you get a load test done on the battery ?

check fuses and links to the main power harness , the jump start may have killed them. ?

you have mutiple problems but start with the battery and some voltage readings

. a full charge doenst mean it has "current/ AMP" drawing power under load it might be dead. but charges to 12 volts still

Edited by sapphiregraphics
Link to comment
https://www.sau.com.au/forums/topic/374717-gtr-wont-start/#findComment-5977123
Share on other sites

I'm thinking it's more like battery and/or alternator because the car runs with jumper leads to another car. If it were any of those other issues (ie broken wires, main fuse etc) would the car still run with the leads connected?

Thanks for your help mate, I'll get the voltmeter out later in the week.

Cheers,

Steve

Link to comment
https://www.sau.com.au/forums/topic/374717-gtr-wont-start/#findComment-5977300
Share on other sites

two fusible links on the battery - check both. if one is broke then SOME of the items work. surprised that you didn't have lights going off in the dash.

as troy said multiple issues. address each one first before putting a blanket patch on it.

Link to comment
https://www.sau.com.au/forums/topic/374717-gtr-wont-start/#findComment-5977454
Share on other sites

Hey,

I have an R32 GTR, recently replaced the battery due to starting problems. This fixed the issue for a while but am having dramas again:

1. I started my car after work to drive home, it started fine but none of the electrics (tail lights, interior lights etc) worked for the entire drive home.

fusible link on the battery. check both.

2. A couple of weeks ago i charged the battery and it started fine.

doesn't mean anything. battery could have been just about at the end of its life. that would have finished it off.

3. This weekend It started with the help of a jump start, however I tried it again today and it started but as soon as the leads were disconnected the car died.

alternator is toast OR battery was simply too flat to 'start' the alternator. I'm leaning on a dead alternator myself.

4. I put the battery charger on the battery whilst in the car but it wouldnt charge at all, the light came on to say the charger is on but the charge light wouldn't light up.

battery is FUBAR..

5. I put the battery charger on the battery whilst out of the car and the charger said the battery is fully charged.

6. I've checked all the fuses and they are all good.

I'm thinking the alternator is probably stuffed and maybe even the new battery aswell. Any help would be greatly appreciated and if anyone has any auto sparkies they could recommend SOR.

Cheers.

see point 5. good sparky can sort the lot.

Link to comment
https://www.sau.com.au/forums/topic/374717-gtr-wont-start/#findComment-5977612
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Initially I thought having a pair of Recaro seats would be a big bonus, it turns out these do get a little uncomfortable on long journeys (my fault, not the seat). I had a look through the GSM Performance website at reclining seats and booked an appointment to visit their show room. I got the Recaro Sportster CS for the R34 from here, was very happy with the service received so of course a re-visit was in order. Unfortunately the two Corbeau seats I had chosen aren't on display but they had 4 other options available. Two seats dug into my back, one dug into my legs and the other was perfect. I also found out that Recaro seats use a larger bolt pattern so some adaption was required. Luckily GSM offer some universal adaptors that should solve this problem. I searched the interwebs for price comparisons and Corbeau themselves were the cheapest at £300 cheaper (for the pair). I asked GSM if they could price match, unfortunately they couldn't. I later received an email saying Corbeau would honour them the same discount, but the purchase was already made. I did however order the brackets from GSM, both arrived on the same day. I started with the passenger side seat, knowing this was going to be a little trial and error. There are 3 mounting holes at the front and 2 at the rear on these JURAN Racing seat rails.  With the adaptor brackets mounted, the allen cap bolts started to push into the seat, NOT GOOD!  The rear mounting holes lined up but there were issues at the front. The holes were 1/2 hole out, so the brackets got a tickle with the drill to modify the holes. The supplied bolts weren't going to be long enough and a spacer was needed to stop the adaptor bars from bending. A local fasteners company supplied be with some nylon spacers and longer bolts (M8x30, although these will be replaced with 35mm long shortly) A before and after I pre-drilled the front bracket before making a start on the driver's seat to save some time. And in no time at all that was in the car too. The all black seats have transformed the interior and these are MUCH more comfortable. The only downside with the new Corbeau seats is I sit a little higher, but I'll happily accept that over discomfort. The Youtube video can be found here: https://www.youtube.com/watch?v=wPyttKPktXA
    • All 3 I guess. The car came with the JASI Aero 4 door Type R Full Kit unpainted so this was one thing at the top of my list to complete then I noticed there were body panels parts for this kit so i picked them up along with some black mesh to fill in the front bumper and front side air vents. car is at a paint and body shop atm completing this work. Next I will be addressing the internal bells and whistles, great summer project I can do with the kids.  full interior removal - ,boys car sound deadening - pads and spray ,boys stereo, sound, lighting - Big 3, GTT or bigger alternator ,kids head lining - dye black add star lighting mod ,daughter. That's it for the next 5-6 months. I have some motor maintenance  work i have to plan out. oil filter relocation, gaskets, mounts. beyond that, mind is starting to turn over if i can use a DET intake plenum, block off turbo ports & pipe in a air intake.      
    • roller coaster of a ride. Alarm system was removed & main harness was repaired where possible. still no fix just random successful starts. moved on to the replacing the ignition switch and relay. well all this troubleshooting & repair has been going on, the car is at a paint and body shop being pushed around. Ive been going down there on odd days after work to get it sorted.     
    • 5th November if you want to come out for a spin wakfield
    • PROBLEM WAS BROKEN COOLANT SENSOR!!! Replaced with a new one and its running mint.
×
×
  • Create New...