Jump to content
SAU Community

What Sensor Is This?

moodah

By moodah,
in Engines & Forced Induction

 Share

Recommended Posts

moodah Apprentice

moodah

Posted
Posted

1) Can someone tell me what the sensor in the red box is for?

IMG_20110810_191454.jpg

2) The oil pressure sender is not in my wiring diagram for the rb30 - Can anyone confirm that the the oil pressure sensor is located driver side, mid rear bottom of the block with a large soft rubber boot?

Thanks in advance guys!

Link to comment
https://www.sau.com.au/forums/topic/377131-what-sensor-is-this/
Share on other sites
Stock e-Tune Contributor

Stock e-Tune

Posted
Posted

Looks like a typical idle control motor..

The oil pressure sender is next to starter motor on the offside towards rear.

in fact, its the only sensor on that side of the block. If you unscrew it, it will leed to a hole in the block, often 80% blocked with sludge.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • hardsteppa
      R-chassis INNER tie rod torque spec?

      By hardsteppa · Posted

      Not sure if you're being serious? I, and all the car people i know, ALWAYS use a torque wrench for wheel nuts. I assumed any car person, apart from tyre centre monkeys with rattle gun in hand, would do it properly.  Anyway, no further reply from me on this unless legit discussion from OP or his query so, over to you, knock yerself out.
    • PranK
      Wheel refurb?

      By PranK · Posted

      I was wondering about this. I'll do some research.
    • Predator1
      Rb26 iron block limit

      By Predator1 · Posted

      Why not? Since mines been built, I've used low boost maybe 5 times.
    • GTSBoy
      gauge needle removal

      By GTSBoy · Posted

      Yeah, so widen your search to any Nissan speedo first, then go wider if needed. I will say though, that there is a better than even chance that what I said first will likely come into play. They quite possibly won't come apart without damage. I tried to disassemble a stepper gauge that I wanted to repair. There was no way that needle was coming off the spindle, and I could not see how the spindle would come out of the mechanism behind. Assembled once, never to be disassembled, was my conclusion. Could be the same on the R34 cluster. Failing that - take the cluster to a workshop that specialises in automotive instrument work. There's usually at least one in every Australian city. They'll either be able to do it for you for small cost, or tell you it can't be done. It might be that "it can't be done" unless you follow some arcane procedure, including trickiness to glue it back together or something, that only experienced techs know.
    • GTSBoy
      R-chassis INNER tie rod torque spec?

      By GTSBoy · Posted

      Well, given that I, an engineer, almost never bring out the torque wrench to tighten up chassis bolts, despite fully knowing the theory, and instead rely on feel, which I happen to know is exactly how the majority of mechanics do things, should tell you the level of actual peril that exists from not achieving exactly 88 Nm of torque. How about if I just say then that 88Nm is at the lower end of the correct wheel nut torque range? Everyone knows how to tighten a wheel nut, right? And almost no-one ever brings out the torque wrench for that task
×
×
  • Create New...