Jump to content
SAU Community

Recommended Posts

I listed this up recently but have dropped the price a lot (read: $3000!).

Previous owner was a mature lady owner who imported it and who owned it for around 5 years.

Here are the details:

Interior:

the interior is very clean with only a single slight mark on the rear seat that is almost unnoticeable

Power windows

power steering

power mirrors which fold back into the car so that they dont get damaged

air con only needs regassing

kenwood equalizer and cassette player with a 10 cd stacker in the boot

climate control

blitz turbo timer

fully electric sunroof with open/close and tilt up and down feature

Engine:

2.0L six cylinder turbo

automatic

144,000 klms with a full log book service history (serviced every 5000kmls)

mechanically a1, drives wonderfully

cat back 3" sports exhaust with a large tip, but everything else is stock

4 brand new brake pads

i have never boosted the car, and it is never flogged

Exterior:

The paint is in very good condition with just the usual little scratches and marks because it is a daily driver, but overall, it is very good paint.

Red/maroon

bodykit with a front bar, side skirts and a rear spoiler (i think the rear bar is stock)

driving lights

17" mags with a chrome deep dish (look really good)

4 near new 235 tyres on each corner

camber adjustment kit so that you dont chew through the tyres

window tint

slimline weather shields that stop the rain coming in the car with the windows down

Now the couple of bad things:

it has a small (5 cent piece size) piece of rust near the back window. Very small though.

There is a little rust on the edge of the sunroof because the rubber just doesn't seal perfectly against the opposite surface. The sunroof does not leak whatsoever though.

This really is a great car, that runs wonderfully and without a problem, but it most be sold!

It has a full 12 months NSW rego on it now. I think it was March 29th.

The car is located in Murwillumbah which is on the east coast about 30 mins south of the qld/nsw border or about 1 and 1/2 hours south of brisbane.

Price: was $13,990 for the car, now only $12,990!

now $12,500 because of power window (see post down the bottom)

Thanks guys

43_1_b.JPG

c7_1.JPG

98_1.JPG

a0_1.JPG

Link to comment
https://www.sau.com.au/forums/topic/37922-fs-92-r32-gts-t-must-sell/
Share on other sites

  • 3 weeks later...

dam power window on the drivers side stuffed itself today... it still goes down to about halfway and goes back up on its on but wont go down any further than that :) i have dropped the price another $500 to $12,500 but i cant go any lower....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...