Jump to content
SAU Community

19X10 +17 Racing Hart Rs721 W/ Hankook 265/30 90%

SRB
 Share

Recommended Posts

SRB Veteran

SRB

Posted
Posted (edited)

set of 4 racing hart rs721 wheels

they are good condition , one has slight marking on the outer edge, its not a rash its ever ever so slight, the lightest little mark around the whole wheel looks like it was lightly dropped face down when the tyres were fitted but i never noticed it till a few weeks later after getting the wheels on! and a slight mark also

tyres are hankook ventus 90% 265/30/19

paid 4k for rims and 1k for tyres

$3250

free delivery east coast of aus

located in sydney

IMG_9453.jpg

IMG_5737.jpg

IMG_4878.jpg

IMG_7038.jpg

IMG_8293.jpg

IMG_5564.jpg

IMG_4100.jpg

Edited by SRB
  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...
  • 4 weeks later...
Tbogtr Rookie

Tbogtr

Posted
Posted

hey just wondering if u still have the wheels? what offest are they? are they same size all round? no buckles just gutter rash? free delivery to south brisbane? whats the lowest ud go (price wise)?

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...