Jump to content
SAU Community

Recommended Posts

WRECKING 1993 R33 Gts-t

will be getting this car home tomorrow so will be able to get alot more pics and details then will also go over the condition of everything listed

Burgandy in colour most panels have some damage.

lower drivers control arm and tie rod are bent everything else sus wise looks fine

The car was stock for nearly all its life recently had exhasut filter bleed valve and ran a massive 9psi

PARTS FOR SALE:

18" Chrome rims (might be starcorps) little bit of dish (some minor rash) tyres will need replacing $700 will need crap rims as part exchange so i can keep the car rolling for now

GTR rear spolier and boot in good condition $200

GTR style front Grill $80

Complete Brake package (calipers/rotors/lines) $**OFFERS**

Stock Turbo and manifold $300 (will confirm condition when i remove)

Sideskirts (400r style i think) minor damage more inside the arch not that visable $80 pair

Tail lights $100 pair or $60 each

Full 3" Exhaust system with HKS super dragger rear sections $350

another rear exhuast section (bolts right at back of car) with muffler $50

Stock Fuel pump $40

Stock Steering Wheel (non airbag) $150 seems mint condition but will check again once i take the cover off :)

Headlights (only 5 months old) great condition just need a clean dont think they genuine nissan $350 *ON HOLD*

Air con pump and lines will check on condensor condition $100

Stock Intercooler kit and all pipework (even has plastic air scoop) does have some oil in pipework but will try clean $100

non air bag dash $100 pretty sure was good condition will check

Centre console $80

Strut Brace $80 (will check brand)

Stock Diff (non abs) $60

Door trims $40

Skyline floor mats $*offers* (will sus condition)

Carpet $*offers* (will sus condition)

all windows apart from windscreen $*offers*

****ALL PRICES ARE NEGOTIABLE****

STUFF IM KEEPING FOR THE MOMENT:

Engine

Gearbox

Engine Loom

ECU

Front cross member

Tailshaft

no doubt there are many parts i havent thought of so if your chasing something let me know!!

Car will be located in the Northern suburbs of Adelaide

contact me via PM or [email protected] or SMS me on 0417080960

post-4329-0-97595800-1319935379_thumb.jpeg

Edited by shy_s6
  • Replies 67
  • Created
  • Last Reply

Top Posters In This Topic

Handbrake set up sold

strut brace sold

drivers window switch and regulator sold

Seats Front/rears (drivers seat has been patched but looks alot better then a hole) with matching door trims and rear trims $250 the lot few minor marks but other then that looks the goods :)

carpet seems to be in excellent condition $ **offers**

Edited by shy_s6

got the turbo off and she looks very mint.. almost to mint so did a quick search and it has twin blades on front wheel meaning its from a series 2 or its been rebuilt at some stage?? anyone got more info on how i can find out whats in it?

PRICES DROPPED ON SOME BITS

$300 for the headlights due to finding a crack in one of the mounts (not broken off) which really doesnt have any effect on the lights

$60 for gtr grill

$50 for sideskirts need a bit of TLC

the seperate rear Exhaust section is made by Kakimoto $50

Full Exhaust system consists of 3' dump/front pipe full 3' system with HKS super dragger muffler sounds really good $300

Turbo $400

Centre console $60

floor mats ON HOLD

central locking actuators SOLD

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...