Jump to content
SAU Community

Recommended Posts

Hi everyone. Due to unforseen circumstances i may need to sell my car.

It is a 1/95 r33 manual coupe in the ever popular white. Has done 125000km

Tidy car, stock apart from cat back and kn filter in airbox.

Hoping for between 7-8000 but open for offers. i will post pics when i can.

Edited by Kiwibob
Link to comment
https://www.sau.com.au/forums/topic/382001-eoi-1995-skyline-gts25t/
Share on other sites

I didnt have a chance to edit post yesterday to add more info.

Car is running stock boost, never gone over factory. Factory alloys in very good condition with 225's that are around 5000km old.

Clean interior, repainted centre console. Steering wheel has leather peeling a little and the gear and handbrake boots are a little worn.

The only bad bits are the turbo gasket is leaking but only when cold, the noise dissapears after 2 mins. i havent replaced gasket yet as i also have a 3" front pipe that i was going to install and do gasket at same time.

Small bubble of rust under rear wing on boot lid.

And brakes could do with bleeding.

Been a very good car and i will be very sad to see it go.

Thanks



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...