Jump to content
SAU Community

Recommended Posts

  • Replies 5.5k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

The Pirelli tyres played a big role in the 2012 season and the Italian manufacturer has produced some interesting statistics.

The total numbers of tyres used in 2012 was 23,500 (21,400 dry tyres and 2,100 wet tyres), all of which were then recycled.

The average life span of a dry-compound tyre in 2012 was 180km , while the average life span of a wet compound was 140km.

The most challenging corners of 2012 from a tyre point of view were India's turns 10 and 11. The longest continuous energy input into a tyre was recorded in these corners.

Sauber's Kamui Kobayashi did the most laps on Pirelli's hard tyre in 2012 (798); Williams' Bruno Senna did the most on the medium compound (869); Toro Rosso's Daniel Ricciardo the most on the soft (1,012); and Lotus's Kimi Raikkonen the most on the super soft (237). Ferrari's Fernando Alonso completed the most laps on intermediates (145), whilst Kobayashi did the most on wets (104).

The soft-compound tyre was used for the most kilometres over the 2012 season: 123,270in races and tests. The medium compound was used for 121,840km, the hard for101,692km, the super soft for 21,993km, intermediates for 13,770km and wet-weather tyres for just 7,930km.

McLaren's Lewis Hamilton reached the highest average speed on Pirelli tyres this season - 248.241km/h in qualifying for the Italian Grand Prix. At the other end of the scale, Michael Schumacher's Mercedes averaged just 161.828km/h to set the fastest time in qualifying for the Monaco Grand Prix.

There were 957 pit stops in 2012 (of which 14 were drive-through penalties and two stop-go penalties).

The average number of pit stops per race in 2012 was 47.9, an average of 1.9 per driver.

The Malaysian Grand Prix featured the most pit stops (76) whilst the United States Grand Prix featured the fewest (24).

Pirelli's tyre fitters took 124 air and track temperature measurements every race weekend in 2012 with the coldest track temperature during a session recorded in the United States(11 degrees Celsius) and the hottest track temperature recorded a week later in Brazil (55 degrees Celsius).

The highest ambient temperature during a session in 2012 was recorded at the European Grand Prix (37 degrees Celsius) and the coolest ambient temperature was at the United States Grand Prix (4 degrees Celsius). Still, at least it wasn't as cold in the United States as it was in Jerez for winter testing where the temperature dipped to -2 degrees Celsiusduring one particularly chilly session.

13 different drivers and 8 different constructors led at least one lap in 2012. For the drivers, Sebastian Vettel led the most laps (368) from Lewis Hamilton (229) and Fernando Alonso(216). For the constructors, Red Bull led the most (434) from McLaren (365) and Ferrari(217).

Not only did Kimi Raikkonen finish every race in 2012, he also completed the most racing laps: 1,191. Ironically his Lotus teammates, Romain Grosjean and Jerome D'Ambrosio, registered the fewest (803 and 53 respectively).

Lewis Hamilton started on the front row 11 times, three times more than Sebastian Vettel who had the second most front-row starts. Hamilton also outscored Vettel 7-6 in pole positions.

Constructors' champions Red Bull completed the most race laps (2,293) in 2012, bottom-ranked team HRT completed the fewest (1825).

Edited by ctjet

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...