Jump to content
SAU Community

Recommended Posts

Wasn't a bad day out... track temperatures seemed a bit hot, managed to find a couple of loose hoses which are now addressed.

Was going to call you Pete but didnt have your number on hand, didnt get there till 11.30am or so...

Hardly anyone turned up in the morning. Good but cause get more track time to ourselves. Only got held up in the second session by some Commo's.

Afternoon more people, but still got some very good runs. Gotta do something about the engine temperature though.

This is my last outting with the arrowz for a while now. Gotta get a proper intercooler and a Power FC.

Guest Diabolik1

I came at around 2:30pm

Saw a R33 GTR in the garage, a grey R32 GTR and a Gunmetal grey R32 GTST (Morgs, i think it was yours but didnt see ya anywhere)

I left after about 30 mins...no 'lines were on the track, only a couple of V8s, a red Type R, red WRX and a Yellow BMW...



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...