Jump to content
SAU Community

Recommended Posts

Wasn't a bad day out... track temperatures seemed a bit hot, managed to find a couple of loose hoses which are now addressed.

Was going to call you Pete but didnt have your number on hand, didnt get there till 11.30am or so...

Hardly anyone turned up in the morning. Good but cause get more track time to ourselves. Only got held up in the second session by some Commo's.

Afternoon more people, but still got some very good runs. Gotta do something about the engine temperature though.

This is my last outting with the arrowz for a while now. Gotta get a proper intercooler and a Power FC.

Guest Diabolik1

I came at around 2:30pm

Saw a R33 GTR in the garage, a grey R32 GTR and a Gunmetal grey R32 GTST (Morgs, i think it was yours but didnt see ya anywhere)

I left after about 30 mins...no 'lines were on the track, only a couple of V8s, a red Type R, red WRX and a Yellow BMW...



  • Similar Content

  • Latest Posts

    • Hi all, I’ve just finished fitting the timing belt on my RB25, following the standard procedure: rotate the crank twice, release the tensioner, then tighten it down. The belt feels tight, and you can see that clearly in the picture below I’ve heard some people say it’s actually better for the belt to be slightly loose rather than too tight, as excessive tension can lead to snapping. So that’s in the back of my mind. What I’m seeing is this:  • At idle, the belt looks fine.  • But when cranking and especially when revving (around 3–4,000 RPM), there’s a momentary flap/flex or flicker in the belt, which I’ve tried to capture in the video. So my question is — based on what you see, is this slight belt movement something you’d consider normal, or am I just being OCD? Could this amount of movement cause sync issues? Or is it just a harmless bit of flex under load?   from what I know belt flap and flex is expected when crank spins up and pull cam with it Would appreciate any thoughts or similar experiences.     IMG_7656.mov IMG_7657.mov
    • I've replaced the front brakes of my NA to 324 brembos and 350z calipers: i'm going for 225/40-18 up front and 245/35-18 in the back. I have Rays 7.5*19 ET35(225/35) in the front with 5mm spacers otherwise the calipers "lock up/ won't rotate". When i use the calculator i come up with 8*18 ET30 for 225/40...... but not sure i get problems with the calipers. Anyone riding around with 18 inch. that can confirm "that it'll fit"? In the back it's 7.5*9 ET30 (245/30) with the 5mm spacers, but there is no problem with the standard small brakes, so i want to take 8.5*18 ET25 (245/35).
    • Lol.. but then.. always come back to a JDM..
    • Glad to hear. If possible, get your tuner to check air's to make sure everything is still where it should be.
    • The problem with FB/Insta/Reddit etc comments relating to cars is simple. You get to ask a question once, and get one round of replies. For things that can actually be answered in a few lines of text, once, it's fine. After 6 hours, your original question is lost to the void. There are no follow ups, additional questions, anything. No project car is ever such a simple list of questions to ask. You need discussion.
×
×
  • Create New...