Jump to content
SAU Community

Recommended Posts

Hey guys

Ok i have a fair few parts that are in my garage and need to go.

All parts are located in brisbane but can post anywhere at buyers expense.

Here we go

-RB25 oil cooler with braided lines and sandwich plate $250

-Greddy washer bottle to suit R33 $150

-N1 RB25 water pump $100

-Oil catch can painted black. 2x entry holes. 1x breather hole. 1x return to sump hole $200

-Just Jap blue silicone radiator hoses to suit R33 $50

- RB25 S2 coil pack loom $100

-Z32 AFM (no plug) with apexi pod filter $200

-4 core alloy radiator to suit R33. Unsure of brand $350

-Garrett turbo beanie. Ok condition $100

-Direct clutch services 5 puck button clutch with flywheel to suit RB25 (rebuilt 1500kms ago) $450

-3 1/2 inch cat back, then 4 inch from hot dog back to 5 inch HKS cannon to suit R33 $400

PM me for any questions guys.

Sorry about the pictures.. All taken from Iphone

IMG_0194.jpg

IMG_0195.jpg

IMG_0196.jpg

IMG_0197.jpg

IMG_0199.jpg

IMG_0200.jpg

IMG_0201.jpg

IMG_0202.jpg

IMG_0203.jpg

IMG_0204.jpg

IMG_0207.jpg

IMG_0209.jpg

IMG_0210.jpg

IMG_0211.jpg

IMG_0212.jpg

IMG_0213.jpg

IMG_0178.jpg

IMG_0179.jpg

IMG_0180.jpg

Edited by RIPS_R33
Link to comment
https://www.sau.com.au/forums/topic/385231-massive-parts-clean-out/
Share on other sites

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...