Jump to content
SAU Community

Recommended Posts

Hey SAU

I just walked outside to start my R32 and it point blank refused to run. It will turn over and begin to start, but then instantly stall before you can build revs.

A few days ago, I had to take a recirculation pipe off the BOV and give it back to my friend for him to sell his car. I then replaced it with the blanking plate which was on the car when I purchased it (for hectic dosing, yo) and reset the ecu. Before you say this is the reason, the car ran for months with the plate on it until I could get a recirculation pipe. So chances are this is not the cause of the problem.

I'm guessing it could be fuel or vaccum/intercooler piping related but since it's an aftermarket fuel pump, I can hear it whirling away when I put the car in acc, as well as the injectors fueling when I start it.

Mods:

PWR return flow FMIC

Stock R34 RB25 turbo

Yellow jacket coilpacks

3 inch turbo back exhaust

greddy prospec II EBC

Bosch 040 fuel pump

If anyone has any ideas or thoughts before I do something drastic, it would be much appreciated.

Edited by Truffles
Link to comment
https://www.sau.com.au/forums/topic/387454-r32-gts-t-starting-problem/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...