Jump to content
SAU Community

Jdm Sale - R33 Skyline Performance Parts Plus Loads More! Rb25

xclusiv
 Share

Recommended Posts

xclusiv Enthusiast

xclusiv

Posted
Posted

Im selling all the performance parts from my car and returning it to stanard

All parts are either brand new or less than 2,500kms old

Heres the link below:

http://adelaide.gumtree.com.au/c-Cars-Vehicles-Motorbikes-Parts-parts-accessories-other-parts-accessories-JDM-Sale-R33-Skyline-Performance-Parts-Plus-loads-more-RB25-W0QQAdIdZ346399886

Prices are negotiable

pics can be sent to serious buyer only via email

:thanks:

Pepsinator Experienced

Pepsinator

Posted
Posted

about your nismo floor mats

i noticed in your FS thread you dont have the rear centre floor mat in your car?

so you only have

both front and rear mats but missing the centre?

Spunky Munky Grand Master

Spunky Munky

Posted
Posted

Hey mate,

I'm after the pillar trims (where people usually mount there gauges) on the driver's side. Please PM me a price if you have these.

xclusiv Enthusiast

xclusiv

Posted
  • Author
Posted

All parts are listed, please read the add pinch.gif

All Parts are in link below -

http://adelaide.gumtree.com.au/c-Cars-Vehicles-Motorbikes-Parts-parts-accessories-other-parts-accessories-JDM-Sale-R33-Skyline-Performance-Parts-Plus-loads-more-RB25-W0QQAdIdZ346399886

thanks :thumbsup:

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • turbo76lx
      Torana Lx Gtr Hatch, Lots Of Pictures

      By turbo76lx · Posted

      Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • joshuaho96
      Jacks that fit under GTR lips that can reach the subframe?

      By joshuaho96 · Posted

      Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Kapr
      Boost cut after swap(RB25DET NEO) R34

      By Kapr · Posted

      Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • GTSBoy
      Jacks that fit under GTR lips that can reach the subframe?

      By GTSBoy · Posted

      I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
    • GTSBoy
      Most women will agree that parking is the most taxing part of driving

      By GTSBoy · Posted

      Well, yeah. But I just expect everything other than my car to feel like a bucket of shit anyway. I still miss my Alfa 116 so much though. You could run over a 20c piece and tell whether it was heads or tails.
×
×
  • Create New...