Jump to content
SAU Community

Recommended Posts

I'm Looking at getting my Stag tuned with the nistune board......And Just want to know what Mods people have done before getting it done....and also what they used brand wise...

I was thinking:

Coil packs ,Yellow jackets or Splitfires or something

Fuel pump ?

Electronic boost controller ?

I already have 3" turbo back and FMIC

Any input would be appreciated

Cheers

Link to comment
https://www.sau.com.au/forums/topic/388648-help-with-mods-before-nistune/
Share on other sites

Definitely get a new fuel pump - Deatschwerks, Denso, Nismo, Bosch 044 and wire it directly for full voltage (with a relay - tutorials on this site) and change your fuel filter. Do you have a high flow panel filter? Whatever air filter you use check to see if it needs replacing.

Are you having problems with your coils? If not you can replace them anytime and won't affect your tune. Just replace your plugs and gap them down to 0.8mm and thouroughly clean your coils and maybe spray them with a sealant.Oviously you can run too much boost if you're on the stock turbo but a good ebc will enable you to hit max boost more quickly. I iwll be using the Link so can't advise you on which ebc.

Cheers thanks for the info.....Yeah I currently have a flat spot at 5000rpm thinking its the coils tried taping them up as well as a high temp sealant ...with no change....I just don't want to get the car on the dyno and something like that fail and have to get it re tuned later........Change spark plugs recently and re gaped them to

I've got a pod filter and in the proces of making a cold air box for it.....

Thanks again ....

Have a look at these:

http://www.ebay.com.au/itm/NISSAN-SKYLINE-R33-RB25-GTST-SERIES-2-R34-RB26-GTR-FULL-SET-NEW-6-COIL-PACKS-/330671882812?pt=AU_Car_Parts_Accessories&hash=item4cfd94823c

I bought a set off this guy and they are in my car now. I had a set of new Yellowjackets but when I saw these I snapped them up. OEM are the best - they have lasted 15 years in my car and there are no Splitfires with a record of service that long!

Splitfires or new OEM coils will be needed at some point on a neo engine however you don't need to replace them unless they are breaking down. Unfortunately if they break down under load on the dyno then that is the end of the tuning session. Your call on this one.

Fuel pump...yes.

A manual boost controller will do the job like TurboTech if you are going for electronic then Profec B is pretty reliable and not too expensive.

What plugs did you use?

Are those actually OEM coils in that advert or "OEM quality"??

Splitfires or new OEM coils will be needed at some point on a neo engine however you don't need to replace them unless they are breaking down. Unfortunately if they break down under load on the dyno then that is the end of the tuning session. Your call on this one.

Fuel pump...yes.

A manual boost controller will do the job like TurboTech if you are going for electronic then Profec B is pretty reliable and not too expensive.

What plugs did you use?

Are those actually OEM coils in that advert or "OEM quality"??

Yep new in box right part number fit and work perfectly. They are so cheap I am tempted to buy another set but in 15 years time I might have forgotten where I put them!

Cool, with all the gear coming out of china it is hard to tell what is the real McCoy and what is a copy in the same casing.

Chinese copies can be bought under $100 for a set of six, plus freight

Cheaper in bulk

Plenty of mark from people like justja....etc

Splitfires or new OEM coils will be needed at some point on a neo engine however you don't need to replace them unless they are breaking down. Unfortunately if they break down under load on the dyno then that is the end of the tuning session. Your call on this one.

Fuel pump...yes.

A manual boost controller will do the job like TurboTech if you are going for electronic then Profec B is pretty reliable and not too expensive.

What plugs did you use?

Are those actually OEM coils in that advert or "OEM quality"??

Thanks for your help...

Ill prob just get a set and be done with it......

Im using the NGK plugs at the moment....cant remember the model number i got it off the forum...

thanks Again for your input...

Yep new in box right part number fit and work perfectly. They are so cheap I am tempted to buy another set but in 15 years time I might have forgotten where I put them!

Is there any advantage going Splitfires over the OEM's........i know the splitfire website will say they are heaps better,,,,,,

No unless you like blue. They are heaps better than 15 year old OEM but as I say the OEM ones have the track record. Not saying there is anything wrong with Splitfires.The main reason people bought Splitfires was that they were half the price of OEM but the ones in the link are even cheaper than Splitfires (or Yellowjackets) and at least two forum members (including me) are happily using the linked ones in their cars

I'm in a similar position. I have a Greddy BOV that was removed for an inspection. Is there any benefit to reinstalling when I get a Nistune?

Has your car lost 50% (or any) of its power since you went back to stock ?

If it was plumbed back you could put it back as it is presumably quite new but if it was venting to atmosphere I would be inclined to stick with the stock one and sell the greddy to someone who wants a noisy bov.

The flat spot at 5000rpm is in the stock tune, it will still be there even with new coils. The stock map drops a few degrees of timing at the 4500-5000rpm mark then adds it back in around 6000rpm.

Just echoing what the others said, get a good fuel pump and change the fuel filter. Get a boost controller, manual or electronic. Unless you know for sure you coils are dying I would leave them.

Has your car lost 50% (or any) of its power since you went back to stock ?

If it was plumbed back you could put it back as it is presumably quite new but if it was venting to atmosphere I would be inclined to stick with the stock one and sell the greddy to someone who wants a noisy bov.

I don't believe there has been any power loss since going stock... If it isn't going to provide any gains the I think I'll steer clear. Don't want to attract any unwanted attention from the fuzz :)

The flat spot at 5000rpm is in the stock tune, it will still be there even with new coils. The stock map drops a few degrees of timing at the 4500-5000rpm mark then adds it back in around 6000rpm.

Just echoing what the others said, get a good fuel pump and change the fuel filter. Get a boost controller, manual or electronic. Unless you know for sure you coils are dying I would leave them.

Thanks for your input

Thats good to know,,,,,,, Is there a way that i can test the coils to make sure there fine because as i mentioned i don't want to get the car on the dyno and have one of them fail.......then buy new coils then pay for dyno time again......

It just seems like a pretty common thing to go on the RB's........whether its now or in 12months time....i could be wrong.........

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...