Jump to content
SAU Community

Recommended Posts

I did this car a couple weeks ago now but have only just got around to doing the thread for it.

This was a 2 stage polish using meguiars polish and lake country pads on my flex DA.

The car was then treated to 4 coats of Swissvax Crystal Rock Wax at $1500 a tub!

Ill let the pictures do the talking (note you can almost read the writing on the inside of the hallide light:P)

IMG_0615Large.jpg

IMG_0616Large.jpg

IMG_0604Large.jpg

IMG_0606Large.jpg

IMG_0611Large.jpg

All taped up including the vents on the bonnet!

IMG_0628Large.jpg

IMG_0644Large.jpg

IMG_0651Large.jpg

A couple 50/50 and after polishing shots

5050shot.jpg

IMG_0624Large.jpg

IMG_0631Large.jpg

Zaino Perfect Tire Gloss

IMG_0658Large.jpg

IMG_0660Large.jpg

IMG_0664Large.jpg

Great Mettalic POP!

IMG_0672Large.jpg

One of four coats of Crystal Rock

IMG_0686Large.jpg

Reflection? you like?

IMG_0695Large.jpg

IMG_0696Large.jpg

IMG_0711Large.jpg

Outside shots it was a little overcast unfortunatly :(

IMG_0719Large.jpg

IMG_0724Large.jpg

IMG_0726Large.jpg

IMG_0727Large.jpg

IMG_0728Large.jpg

IMG_0733Large.jpg

Hope you enjoyed!

Link to comment
https://www.sau.com.au/forums/topic/392259-aston-martin-vantage-detailed/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...