Jump to content
SAU Community

Recommended Posts

It is recommended that if you have to use the spare, put it on the front.

Less chance of damaging driveline due to the front diff being an open differential, so wheels can freely spin at different speeds.

If you put it on the back, you'll probably burn out the plates in the limited slip diff...

So if you've got a puncture on the rear, put up with the fact that you'll look totally stupid putting the spare on the front first to get that front wheel; attracting comments like, "Oh look at the 2 digit IQ mechanic! He's replacing a totally good wheel with a spare & he doesn't even realise he's got a flat at the back!" > guffaws

80 Km/hr speed limit on the spare BTW and you may feel the car brake (or steer) slightly to one side

Guess if u had a flat in the rear, put good tyre from the front to the back, then spare at front

Would be abit annoying changing 2 tyres on the side of the road :(

I considered doing it once, then remembered I had RACQ (Queensland road assist), poor fella.

I always assumed two proper wheels on the front would be beneficial somehow, also my front brakes don't allow for the spare to fit over the caliper.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Lamb roast on Saturday will be different 🥲
    • They are under bucket shims. Tomei provides a test shim kit and then any measurement of shim required. 
    • I always wondered how you were supposed to buy a set of 24 buckets and somehow magically have every single one of them yield exactly the desired clearance. I would have thought you'd need to assemble a cam with either 12 "sample" or "example" buckets of known top thickness (or a single such sample/example 12 times over!!) measure clearances at every valve, and then do the usual math to work out what the actual "shimness" of each bucket needed to be, before buying the required buckets to make up he thicknesses that you didn't have on hand.
    • I now seem to be limited in power due to my rev limit/hydraulic lifters in my built RB25. I'm looking into converting over to Tomei solid lifters. Question for anyone that has done the conversion. I was always under the impression that when using the Tomei solid lifter conversion, you would also require new valves (Longer or shorter stems, I can't remember which).  I don't know where I got this idea, as so far I see no mention of this in any of the Tomei documentation. It just states I need the Tomei solid buckets, solid lifter cams and upgraded springs. As my head is already built, all I would need is another set of 1000$ Kelford cams, 500$ buckets and about 4H hours of my time installing and I'm off to the races!?!? There's no way it's that simple, I must be missing something? 
    • I couldn't agree more. I should have started from the get-go with a NEO or solid bucket conversion. I started looking into converting over to solid lifters yesterday. Now for some reason I was always under the impression that when using the Tomei solid lifter conversion, you would also require new valves (Longer or shorter stems, I can't remember which).  But I see no mention of this on any of the Tomei documentation. It just states that I need the Tomei solid buckets, solid lifter cams and upgraded springs. As my head is already built, all I would need is another set of 1000$ Kelford cams, 500$ buckets and about 4H hours of my time installing and I'm off to the races!?!? There's no way it's that simple, I must be missing something? 
×
×
  • Create New...