Jump to content
SAU Community

Driving a auto in Overdrive bad?

Leon.T
 Share

Recommended Posts

strutto Grand Master

strutto

Posted
Posted

The OD button in a 33 disables 4th gear when unpressed (ie when the light on the dash goes on... The light incidently says O/D off)...

So no, overdrive doesn't make the revs go UP, but I understand where your coming from Karina...

Driving with the OD enabled (ie light off) won't cause any problems...

WazR32GTSt Grand Master

WazR32GTSt

Posted
Posted

i have an auto mate so this is coming from experience...

i only turn o/d on when i'm over 70km/h. reason? with the button pressed in the car constantly tries to drop to the highest gear. often with just the touch of the accelerator it can try to jump from 4th back to 3rd then into 4th again.

when you accelerate from low rpm in 4th gear you are placing a large load on the gearbox and this ain't the best.

easiest is to:

1) get a trannie cooler (i picked one up for $80 at supercheap)

2) leave o/d OFF in traffic

3) turn o/d ON when you hit a long road / freeway and are over 70km/h

good luck!

Waz.

R31Nismoid Grand Master

R31Nismoid

Posted
Posted

yeah, OD is only for 70-80km or above.

You wear the auto out if you have it in OD at 50 i was told it wore out the box quicker due to the low revs or something.

Wonder if there is an truth to that statement or not.

T0nyGTSt Grand Master

T0nyGTSt

Posted
Posted
yeah, OD is only for 70-80km or above.

You wear the auto out if you have it in OD at 50 i was told it wore out the box quicker due to the low revs or something.

Wonder if there is an truth to that statement or not.

Not on Skylines but it was true on the early Turbo 700 automatic boxes on VN/VP Commodores.

T.

Rollin Apprentice

Rollin

Posted
Posted

ok, short lesson in autos - they arent magic things.

"overdrive" just means any gear which when selected makes the output shaft on the gearbox spin faster than the input shaft (which is attached to the engine)

most 5 speed manuals have 5th as an "overdrive" 6 speeders have 5th and 6th overdriven as well.

so, if you wish to drive around with all 4 gears the gearbox has to offer, then leave overdrive on. if you dont, turn it off and the box will behave like a 3 speeder, allowing only 1st, 2nd and 3rd gears to be selected.

the benifit of allowing 4th to be used is better fuel economy, then benifit of turning it off is slightly better engine braking (saving your pads and dics very slightly) and less shifting through the gears if you are only driving at low speeds all the time, this in theory means your gearbox lasts longer and runs cooler.

the choice is yours, there really isnt a "right" and "wrong" way - just do what you prefer.

but yeah, get a big-ass oil cooler for your auto anyway, it would be the first mod i would do were i to buy an automatic car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      After market rear camber arm adjustment

      By Duncan · Posted

      Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • V35Newbie
      After market rear camber arm adjustment

      By V35Newbie · Posted

      I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • Duncan
      After market rear camber arm adjustment

      By Duncan · Posted

      You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • V35Newbie
      After market rear camber arm adjustment

      By V35Newbie · Posted

      I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • GTSBoy
      Unpeeling the Orange

      By GTSBoy · Posted

      Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...