Jump to content
SAU Community

Best Street Tyres

Phatboy
 Share

Recommended Posts

eightsixboy Mentor

eightsixboy

Posted
Posted

Ku36's arn't that good, they have bugger all tread on them compared to the rsr's and they get noisy. Cant go past the rsr's for bang for buck.

If you can afford to go ad08's just do that, if its just a streeter then prob wasting money on the ad08's as Im sure the rsr's will be more then fine.

  • 2 weeks later...
Phatboy Mentor

Phatboy

Posted
  • Author
Posted

Thanks guys, super sports fitted. v. happy with it over last couple of weeks, but will take a bit longer to bed them in i think. tire-rack as usual were awesome - delivered to doorstep 3 business days after wire transfer cleared.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Songo
      New kid on the block

      By Songo · Posted

      Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • MBS206
      New kid on the block

      By MBS206 · Posted

      https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Cangorus
      New here

      By Cangorus · Posted

      Hello everyone, I am happy to join you.
    • Duncan
      New here

      By Duncan · Posted

      Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...