Jump to content
SAU Community

Recommended Posts

very quick car, 250RWK at 14PSI boost. Imported and complianced November 2006. 11 months rego.

Engine And Driveline:

Hybrid intercooler kit
Z32 AFM
550 CC DeatschWerks injectors
Walbro 416lph (E85) intank pump
Hypergear TR43i turbo (rated 550hp)
Modified manifold to suit waste gate.
50mm external waste gate
Custom v-band 3inch dump pipe and front pipe
Jasma 3.5inch catback exhaust sounds great
Custom steal 3inch intake pipe
Cold air intake
Tomei Adjustable Cam Gears
Splitfire coilpacks NGK-R spark plugs
Gates Racing timing belt
Strong and good condition rb25 gearbox
Exedy Heavy Duty Button Clutch
JJR custom tailshaft
Standard LSD Diff. will also come with a shimmed diff that is works perfect and is very tight.

New rocker cover gasket
Oil and filter changed less than 200km
Diff oil change
Gearbox oil changed

Interior:
New battery
Alarm worth $450
Interior is clean and looked after
Bride Gias bucket seat drivers
Standard Steering wheel ( Wll also with aftermarket boss kit steering wheel setup)
Pioneer double din headunit
4 6inch sony splits
Greddy electronic boost gauge
Greddy turbo timer
Apexi Power FC ECU. Tuned By Trent at Chequered tuning.
Gizzmo EBC set to 14psi

Exterior/Suspension:

17 inch rims with 235 Tyres all around
Standard series 2 Bodykit
Jun rear bar lip that looks really good and makes it stand out alot more then stock
Custom front lip
Custom Roof wing (very rare!!)
Xenon HID lights
Front Tein HR fully adjustable coilovers
Rear ISC fully adjustable coilovers
Brand new adjustable ISC camber arms
Brand new ISC Hicas lock bar
Brand new Gk-tech lock spacers
Brand new Adjustable Gk-tech rear toe arms
Brand new Gk-tech front castor arms
Brand new Gk-tech rear traction rods
Brand new Gk-tech rear sub frame slip in collars
Brand new Adjustable front tie rod ends

Bad points :
Guards were not rolled properly and now have started to crack could use a sand back and repaint.

Actuator Spring is too soft so is limited to 14psi boost.

Oxygen sensor is not working.

Offers are welcome.

Contact 0413 507 269

Located South Eastern Melbourne.

  • 2 weeks later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...