Jump to content
SAU Community

How To Get Rid Of This Sticky Crap That Has Stayed Behind After Removing Black Side Strip ?!

33gts4

By 33gts4,
in Exterior & Interior Styling

 Share

Recommended Posts

33gts4 Contributor

33gts4

Posted
Posted

I peeled the black rubber strips down the side of my r33 gts4 off the other day, i baked the car in the morning sun and peeled them off. One side came off just like a sticker and didnt leave anything behind. The other side i think may of been reglued on or something at some stage and has left this sticky shit behind?! Tried soaking it with WD40 and soaking it in the sun it is a little bit easier but still so stuck on there. Wondering if anyone has some you beaut way of removing it?!

Any help will be greatly appreciated,

Cheers !

post-106657-0-60677700-1364102074_thumb.jpg

ARTZ Grand Master

ARTZ

Posted
Posted

Hair dryer and you can old credit card or plastic knife...but honestly its often easier with your fingers unforunately..clean with turps ,prepsol,wax and grease remover or maybe bug and tar remover..but dont scrub at it or it will.scratch

ITs a pain in the ass that stuff I know, it wither comes off clean or doesn't come off. My work used to put stickers all over my truck and it was the same deal :/

33gts4 Contributor

33gts4

Posted
  • Author
Posted

Got it all off ! I got a supercheap club plus card and sharpened an edge on the concrete and soaked the crap out of the sticky stuff with 5.56 which is just a cheap WD40. It came off so easy took me 5 minutes to do the whole side of the car when earlier it took me a good 15 mins just to do the tiny but on the front quarter, and didnt mark the paint at all! Would recommend doing this to anyone that gives it a go i was suprised at how easy it came off ! There are still a few tiny specs but i think they should come off with a good polish !

thanks for your help ARTZ, was having a mind blank didnt even think to use a plastic card !

post-106657-0-69994200-1364106529_thumb.jpg

post-106657-0-22398800-1364106674_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • dbm7
      R34 Skyline climate control unit transistor

      By dbm7 · Posted

      That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • bilbo117
      R34 GTR Seats / No longer reclining

      By bilbo117 · Posted

      Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • joshuaho96
      Ethanol Content Sensor - Always at 11%?

      By joshuaho96 · Posted

      The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • GTSBoy
      R34 Skyline climate control unit transistor

      By GTSBoy · Posted

      It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • GTSBoy
      Blue slip

      By GTSBoy · Posted

      South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...