Jump to content
SAU Community

Recommended Posts

For sale is an incomplete project that needs a bit more work to get it on the road. It as a fully working rb30det conversion with rb25de head fully reconditioned with 100lb valve springs. It also has the following,

Fully recoed r32 gtr gearbox

Npc organic heavy duty clutch

New genuine front and rear main seals

Drilled out sump return holes

New CV boots all round

New 52mm rad

Nitto oil pump

Tomei 1.1 oil restrictors

Arp rod, mains and head studs ALL L-19!

SPOOL rods

CP pistons

New timing belt locator holes

New tensioner pulley

New idler pulley

Rebuild starter motor

60mm genuine tial wastegate

T04e t4 top mount turbo

Nismo engine mounts.

New Welsh plugs

New water pump

New JJR interior kit.

Side intake plenty with velocity stacks

New aac valve

New cold start control valve

R32 gtr injectors fully cleaned

Bosch FPR.

BOSCH 040 fuel pump.

New fuel lines

New front brake lines

Fresh rebuilt brake booster

New BM57 brake master cylinder

S14 stubby clutch reservoir

Braided clutch line

Apexi avcr

4wd kill switch

New genuine cam seals

Genuine rb26 head gasket

Mod plated for turbo kit, bigger engine and modified front reo bar

Clear front side indicators

Genuine steering wheel just put back on, needs to be recovered though.

New genuine coil pack loom

New yellow jacket coil packs

Fully balanced engine!

Sorry stuff is all over the shop just trying to remember some things.

Now SOME of the stuff I have receipts for. Due to the qld floods we have had I lost a lot of paper work

it also has nistune ecu which still needs to be tuned

It also needs the dump pipe and wastegate pipe finished plus a few other little things for rwc.

Will post up pics soon

Looking for $25000 ono

Link to comment
https://www.sau.com.au/forums/topic/423001-r32-gts4-4-door-rb30-awd/
Share on other sites

You may want to consider parting out or revising your price if you are serious about selling this, as you are asking tidy gtr money for an incomplete gts4.

In all honesty I don't know how you would go getting this money for a complete car, but it's hard to say without any pics

Sounds really cool, but ^ he is right. Parting it out if you have the time would be the best way to get back some $$. For comparisons sake, there is an R32 with fresh respray, rb30det (300+kw), immac interior, complete ready to drive for $13k on these forums.

Best of luck though, sounds like you've put a lot of time, effort and $ into it so far....shame these cars aren't worth all that much any more....

Yeah true. But 4 door gts4 are becoming rare and so ask a good price. I talked to one import car sales guy in SEQ who's quite well known and he reckons in the right circumstances there's no reason I wouldn't get 30 k for it. I honestly thought the guy was on drugs and a couple of other import car sales people also told me 28 and 27! Due to the fact there is no redbook price for these apparently.

I would be happy with 2004 mkll xr8 manual or 2002 sti. I read the post and I can appreciate where you guys are coming from. But I guess my centimental attachment to it from all my hard work maybe blinding me from the truth of the price. Has taken 2 years of consisting working on it myself to get it there almost nothing has been out sourced other then machning and parts.

^^ call what you want. I have 24k. Thanks very much. The vehicle has been advertised elsewhere for a while and has had several parties interested in it. Maybe next time you should consider a big view of a picture bar what flickers of sight you see...

I just think you are full of shit. This may have been advertised elsewhere, and you may have taken picutres that I wanted to view but could not sight as they were unseen, but from what I read, the engine ran like crap last month, the parts list is not all that impressive, nobody was intersted in buying your engine, you don't provide a phone number in your sale threads so I doubt your seriousness and finally I have my doubts in anybody with any sense having purchased this home built beast for 24k. 7-8k, maybe, but not 24k.

Lol don't need to supply number unless its necessary from a pm and yeah it was running like crap thanks to a warped brand new manifold leaking air, but luckily for me the supplier gave me a brand new one that wasn't, runs like a charm. And secondly did I come to your threads bashing on yous? No so f**k of you rude dream boats jam your heads back up your arses and please keep talking shit elsewhere. The person who bought the car has seen EVERYTHING that has been done and knows the car was done miticuosly. Next time ill come picking on your threads and bashing. If your so f**king bored in life and you get your kicks out of giving shit to people you need a f**king drop kick in the head or your just a pathetic f**k with no life either way f**k off.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...