Jump to content
SAU Community

Recommended Posts

Today is the day that our Australian and cousin country, New Zealand sacrificed their lives in World War I on the beaches of Gallipoli. ANZAC day is also a day to remember all conflicts that has happened to which we have partook in and to remember those who gave up their life and for those lucky few who survived.

Lest We Forget.

Anyone end up going to the Dawn Service?

edit: my bad for some reason i said forgot -_-

Edited by HelgaR33
Link to comment
https://www.sau.com.au/forums/topic/424106-lest-we-forget/
Share on other sites

Up before dawn, held my own service to remember the fallen.

The freedom we ALL enjoy today has been made possible by our armed services and those who support them.

Those men and women went willingly into battle to protect Australia and our freedoms.

Far too many younger Australians forget the sacrifice's made by those who came before them.

I know this by seeing the behaviours and disrespect shown everyday in the home, workplace, the shops and on the streets.

Everyday in everyway I ask that you do what you can to help those in need.

Be tolerant but show no tolerance to those who would do others harm. Stand up and be counted.

It's on us now to protect Australia, our fellow Australians, respect and protect our elderly, the frail and those less fortunate.

Never forget

/end rant

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/424106-lest-we-forget/#findComment-6827405
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...