Jump to content
SAU Community

Recommended Posts

Hey All,

Most of this stuff is quite boring, but I'm sure someone will need it for whatever reason because "youse" got defected by dem coppers, fuark :woot:

R33 Steering Wheel

Leather removed, appears the wheel was dodgily rewrapped in leather

Adhesive removed, all smooth and plesant to use

No physical damage, good to use as is or rewrap in your choice of leather

Does not come with airbag torx bolts, and missing 2x bolt covers

$50

R33 Driver's Air Bag

Off the same steering wheel

Very minimal wear on the RHS (maybe previous owner suffered road rage pumping the horn)

$50

R33 RB25DET Engine Fan Clutch & Blade

Oh mah gord bro, has been modified to suit typical fully sick intercooler kits

Fan blades have been trimmed to fit typical RB25DET intercooler kits

Good to save your fan and buy one precut

$40

Factory Steering Rack Ends/Tie Rods

Surprisingly has no play at all, I bought new ones thinking they needed to be replaced

OEM Nissan rack ends

$20

Factory Steering Tie Rod Ends

Pretty shot, has free play

Free if bought with rack ends

$10

Also have even more boring stock shit:

SMIC

SMIC piping

Cross over pipe & BOV

Down pipe

Dump pipe

O2 sensor

Handbrake boot

HICAS unit

Passenger side kick panel

Location: Canley Vale, NSW OR Surry Hills during business hours

Contacts: Reply here or PM

Photos up tomorrow, having issues with MyNetFone, internet is slow as koala on pot

  • 2 weeks later...

anyone want stock shit? lol :)

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

I like tits

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

like boobies

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

  • 2 weeks later...

Hey mate ill buy the rack n tie rods asap please call me 0422798706

Will SMS now

just a quick question, any idea if the O2 sensor is the same for a R34 GTT? what is the mileage its done?

Hi mate,

I don't believe so, and I'm not too sure how many KMs the O2 has done, the previous owner told me it was replaced during his time.

It looks quite new, you're welcome to come have a look at it and plug it up to your car with a multimeter, but it was working perfectly when removed (car had no idle issues and returned 400km per tank)

  • 2 weeks later...

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

  • 1 month later...

BUMPSKI

R33 S2 Steering Wheel $50

R33 S2 Driver's Air Bag $50

R33 RB25DET Engine Fan Clutch & Blade $40

Factory Steering Rack Ends/Tie Rods $20

Factory Steering Tie Rod Ends $10

SMIC $50

SMIC piping $50

Cross over pipe & BOV $100

Down pipe $40

Dump pipe $20

O2 sensor $10

Handbrake oem boot $10

HICAS unit $20

Passenger side kick panel, 1x flare clip broken $5

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...