Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

If a crank trigger could work easily with the stock ECU or PowerFC I would defiantly be blowing up the CAS

Yep they appear to cause their fair share of headaches.

After Bunta (Andy) explained to me the inherent issues associated with them - having a crank trigger setup is almost just logical really.

So nearly killed my engine today

Had danger to manifold on the HUD and warning sounds and sirens and lights and I looked like this

Posted Image

But seriously nearly killed it

What did you do to it?

What did you do to it?

Silicone hoses yesterday. And boost tee. grandad took my radiator cap off didnt out it back on all the way

Went to supercheapauto this arv drive it like a granny so no boost whole way

Put tee on.

Driving home pulling over and adjusting

Got in.... Drove... Looked down..... Temp was all the way up

Pulled over waited like 30 topped it up and grannied it as fast as I could all the way home

It's in driveway cooling as we speak so I can too it up then go tell my grandad he owes me a vr38

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • It's almost certainly a reluctor generating an "AC" waveform. No, ECUs don't generally read those - they're usually set up for PWM square wave 0-5v stuff.
    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
×
×
  • Create New...