Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

i considered different wheels briefly but then ruled it out almost entirely based on cost vs performance advantage.

the old but reliable RPF01 or the new RS05RR

as seen here but less dish as that level of dishness to them is only avaliable on the 10.5" model which wont fit under the guards, hard to say how well they suit the evo in a 9.5" wheel as they are in limited supply and not a lot of pictures about.

AY0F3456_zpsc70e27d1.jpg

And drift cars?

And choice of orange paint?

i dont have a drift car or the desire to go drifting? i dont even like doing burnouts, its a waste of perfectly good expensive tires.

orange paint because it goes with the colours of the car better than red.

old red

eZa4oHC.jpg

new orange.

H1DCr8A.jpg

i cleaned the wheels up afterwards, but they hide their brake dust well until something touches them.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I have been wondering if this is as simple as a voltage issue with the battery. Even on a charger, I can’t seem to get it over 11.8V on the terminals.    Unless the alternator has failed as well, that wouldn’t cause it to die in the middle of driving though. 
    • I’ll give this a shot next time I’m able to wrench on it.    I was able to get my hands on a Haltech Nexus, so that should help with some of the more bizarre troubleshooting. Make sure the CAS is actually sending signal and will be able to set the proper dwell on the R35 coils.    I’ve checked power/grounds/signals at the CAS, ignitor, and plugs and it was all there. Granted this was static with ignition on, not cranking.    I also plan on swapping out the fuel filter and throwing on a fuel pressure gauge at the rail just to confirm I’m getting the correct pressure at the rail. 43psi if I recall correctly. 
    • The attached document is fine. I just downloaded & opened it.
    • Hello, sorry for being late to join the discussion, but my clock just died on me.   Ive tried to look at Michaels digital clock repair.docx and it doesnt work maybe the file has expired.   Please let me know if you can re upload it or take some youtube videos to show us how to get the clock installed? thanks
    • I thought that might be the case, thats what I'll start saving for. Thanks for the info 
×
×
  • Create New...