Jump to content
SAU Community

R33, S13 And S15 Bits And Pieces

V8skylineMAN

By V8skylineMAN,
in Classifieds

 Share

Recommended Posts

V8skylineMAN Grand Master

V8skylineMAN

Posted
Posted

3x S14 manual gearbox Xmembers.$50 each

R33 rotors and calipers $400
s13 and r33 interior plastics, prices depending on what bit you're after.
R33 doors , L and R, $100 each including door cards and switches
S15 drivers guard $100
R33 front guards, Red ones $80, black ones $100
R34 rb25 block, under 80,000ks on it, rest of engine got parted out $200
R34 rb25 crank $100 no journal damage
New Rb25 sump, never been fitted, no scratches $100
2nd hand rb25 sump, $50
various radius rods(caster rods) let me know what measurement you want and ill see if i have some(i have a milk crate full of them for some reason) All appear to have good bushes in them $25 a pair
R33 caster rod brackets $50 the pair
r33 cross member, drops your rb lower than cefiro or r32 xmember does. $100
R33 lca's $150
S13 digital dash cluster $50
S15 JDM drivers side tail light $50
R33 tail lights $50 a side.
S13 bonnet (black) $80
R33 rear bumper $50
S13 rear bumper $50
S13 veilside rear bumper $50
S13 front bumper $50
S13 front reo, undamaged, uncut $150
will post up more as I remember what I've got...

come get it yourself, I'm not stuffing about posting things.

Located towards Ipswich. Pics available as reqiured

Link to comment
https://www.sau.com.au/forums/topic/434361-r33-s13-and-s15-bits-and-pieces/
Share on other sites
  • 1 month later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      New kid on the block

      By GTSBoy · Posted

      About $4k brand new, available from vendors in Oz, or via an importer from Japan. Although that is for an R34 box, so you also need to buy the push clutch front plate (brand new from Nissan) and swap that over, and drill the bellhousing for a push clutch slave cylinder.
    • nouveau_poor
      Unknown sound similar to BOV on positive boost with partial throttle RB26

      By nouveau_poor · Posted

      Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Bennym35
      New guy

      By Bennym35 · Posted

      Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • Songo
      New kid on the block

      By Songo · Posted

      thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
×
×
  • Create New...