Jump to content
SAU Community

Recommended Posts

Hi guys,

Only just signed up to this forum so really excited to hear your thoughts and ideas when it comes to GTR financing.

At this stage i am looking to get one in the next 6-12 months - It's been on the shopping list for a while now and after just recently going off on my own and establishing my own business i am now in a position where i can afford to do it!

I'm most likely looking to buy one second hand (probabaly 2011-2012) and would prefer a balloon loan arrangement.

Does anyone have any advice for me regarding best interest rates out there atm, nissan financing (are they decent?), importing the car (is this even possible and a cheaper alternative?), any other advice you can give me

Thanks guys and look forward to hearing from you all

Jarret

Link to comment
https://www.sau.com.au/forums/topic/435530-gtr-finance-options/
Share on other sites

You have quite a few options to finance your GTR. As it will be a used vehicle expect rates to be a little higher using major banks. I will eat my hat if NAB will do 5% on a used vehicle. A private broker or even dealer based finance will be your best bet. Be prepared and negotiate not just rate but any origination or brokerage fees.

And remember 5yr 30% balloon equals roughly $40k on a used GTR at $120k so be ready for when that comes around.

Hey Sam, who do you aggregate through?

To Jarret, if Sam isn't practical due to geographic location, let me know where you are and I'll put you in touch with a finance broker.

Also you won't get 5%. Expect closer to 10%.

mmmk so secured commercial loans will attract a lower rate not higher.

the trade of for this is you are not protected by the UCCC cosumer regulations, this realistically boils down to costing more if you cancel early and loosing some protection aginst charges, this is a very basic explanation.

i finance a few of these and im happy to help if you need. just pm me bud.

  • 2 weeks later...

If you are considering buying the vehicle through a dealership i would strongly suggest sitting down with a business manager and tell them you're comparing rates.

Firstly sit down with your bank and see what you can do, go back to the dealer and get them to better it.

This is what a lot of my customers do and end up saving themselves some money.

I am a business manager at Lynford Motors in WA. I Financed a 2010 GTR we sold a bloke in QLD and wasnt difficult.

Rates do depend on a lot but we have bigger buying power than most so our rates are usually a bit lower. A bit on 120K can be a lot though!!!

Give me a call if you want to discuss Jarret 08 9242 9061

I am a business manager at Lynford Motors in WA. I Financed a 2010 GTR we sold a bloke in QLD and wasnt difficult.

Rates do depend on a lot but we have bigger buying power than most so our rates are usually a bit lower. A bit on 120K can be a lot though!!!

Give me a call if you want to discuss Jarret 08 9242 9061

Ahhhh....I thought you were a finance broker.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...