Jump to content
SAU Community

Recommended Posts

Hey guys new to sau and the whole skyline scene. Have got myself a 92 r32 gtst with an rb20 that's sitting on an engine stand currently. I've been replacing bits and pieces such as gaskets and seals before it goes back in so I don't drop it in and find rear seals got a leak etc. I've recently picked up a hks2530 for $200, shaft has slight play with no fin damage, all in all I think it was a good buy but getting back to the means of this post can any of you's recommend a good place in nsw pref closer towards the central coast that will do a rebuild as in new bearings? (Or does the whole chra need to be replaced instead of just the bearings?) any help would be greatly appreciated!

Link to comment
https://www.sau.com.au/forums/topic/438949-hks2530/
Share on other sites

If the shaft play isn't too excessive then for $200 I'd probably just stick the turbo on and see how long it lasts.

If it lasts a year then it's probably worth it. By the time it fails you'll have the money for something better.

Link to comment
https://www.sau.com.au/forums/topic/438949-hks2530/#findComment-7195323
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
×
×
  • Create New...