Jump to content
SAU Community

Recommended Posts

Tomei oil pump very low kms was told 1000km. Havent used it. Reason for selling is I have two of them was going to put it on my current rb26 while I build my tomei 2.8 but just decided to drop the 2.8 in. Was very hard to pick between the two as they are both in about the same condition bought them borh off sau. $1200

Greddy radiator havent used it also as I have an r33 and this radiator is about 2inches taller. Think r34 gtr not sure maybe someone can chime in. $500

Sard 800cc injectors. Also havent used these. Bought off sau. Told 3000km. $500

Genuine momo suede wheel and genuine 5zigen wheel. Suede almost gone on momo. Leather slightly coming away on 5zigen wheel. Both made in italy $150 each

post-85987-0-40919000-1392450060_thumb.jpg

post-85987-0-06691000-1392450089_thumb.jpg

post-85987-0-90721900-1392450109_thumb.jpg

post-85987-0-81906600-1392450134_thumb.jpg

post-85987-0-71123900-1392450171_thumb.jpg

post-85987-0-10307200-1392450234_thumb.jpg

post-85987-0-61633400-1392450268_thumb.jpg

post-85987-0-88962400-1392450788_thumb.jpg

Yeah ive had many offers at that price. I paid $1300 for the pump and havent used it...so im already selling it at a loss

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm actually not sure - I think it was "Stealth Performance" (It really is near impossible to find a FEMALE 1/8BSPT to 1/8NPT male at ALL) but having the thing leveraged on a 90 degree angle on a small aluminium fitting is not too smart. Also in not too smart, I've drilled out the center of the broken fitting so there's maybe 0.00001mm of thread to bite into, so yeah. I may have to get it drilled/tapped/plugged entirely. Given I could conceivably tap a thread/adapter/pressure line in any point in the oil system I suppose it's feasible to run a line to the Nissan Sensor to keep the dash working. Do these exist in AN fittings and the like? Like an AN fitting that has a NPT (or other?) thread as well for putting a sensor in?
    • I would agree.  There will be an amount of boost you could run safely with an otherwise factory system, but it would be low enough to not be worth the cost.  And if you are reliving your 20s, you know a 'little bit' was never enough. Personally, if I didn't want to spend the money, then stick with NA bolt-ons, and maybe a tune.
    • Fuark, at least the motor survived. What brand was the fitting that snapped?
    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
×
×
  • Create New...